Glow Bricks Lego Star Wars X-Wing Starfighter User manual

X-Wing Starfighter
1

Take the shown lighting part to assemble it on the front part of the model
2

Assemble the black lighting plate at the end to the side of the pilot seat
3
Detach the side and the head as shown

4
Assemble the other lighting plate on the detached side then put it back to the plane,
leave the other lighting parts outside the cockpit

5
Assemble the clear lighting round plates the each side on the head
The two pieces of white lighting plates will be assembled at the bottom

6
Take the shown lighting part to assemble it on the rear side
Remove the white 2x2 round plates in the blue circle, leave the clear pink dishes
Put the head back and hide the excess wire inside the gap of the joint (inside the blue
circle)

7
Assemble the lighting plate at the bottom then connect the plugs with the lighting
parts at front
Combine the pink dishes with the lighting parts

8
After that you may take the grey panel off to hide the connected plugs inside
Split the remain lighting parts with one short one long on each side

9
Move the other lighting parts to the upper nozzle, hide the wire under the
plates in the red circle
Assemble the lighting parts with shorter cable on the lower nozzles which are closer to
the lighting plate

10
Repeat the same procedure for the other side then this part is finished
Then assemble it on the nozzle, try to make the wire be hidden as many as possible

11
Get the lighting plate with tile attached to assemble it at the bottom of the wing
(Remember the plane is still turned upside down that’s why it’s bottom)
Take the shown parts to assemble them on the wings

12
Assemble the lighting plate and the lighting round plate shown in red circles
If you take the lighting part with a connector attached by a very long cable, leave it on
the side, they would be used to connect the USB cable at the end

13
Remove the shown part, except the led strip move the remain lighting parts through it
and place the wire in between the studs. Then restore the part and stick the led strips
inside the grey circle

14
Now assemble the lighting parts on the other side, basically it’s same way as before
Connect the plugs with the lighting plate at the bottom

15
Then assemble the remain 1x4 lighting plates on the front panel

16
After connecting the plugs, you may turn the plane around to assemble the remain
lights
Open the wing and assemble the lighting plate at the red circle place

17
And stick the led strip
Then assemble the lighting round plate

18
Restore the plate and this side is done
To make it looks better, hide the excess wires and the connectors inside the body

19
If you want to power by battery, connect the small battery case with the lights
of the head side and stick it inside the head
Now repeat the same procedure on the other side

20
At last, replace the lightsaber by the lighting saber, connect both connectors to the USB