Glow Bricks Motorised Lighthouse Lego 21335 User manual

1

2
Firstly detach the roof of the house and the wall of the lighthouse facing the house

Then remove some red bricks from the roof to get the lighting fire installed on the
chinmey
3
Take the lighting part with white 1x6 plates and assemble them and the lighting
yellow round block

Restore the removed bricks and the roof back to the house
4
Then starting assembling the 1x2 brown lighting plate to the bottom window

5
Once the lighting plate installed, restore the wall to the lighthouse and start the
installation for the upper level
Keep it until all three windows are assembled

6
There’re 8pcs of lighting round plates follow by the 1x2 lighting plate from the last
step, pull them to the top of the lighting house and assemble them around the
bottom of the big black round plate as shown

Start from the top level this time, assemble the black lighting plate above the
window like this
7
Then remove the wall for the other side of the lighthouse to install the lights
Pull the remain lights through first

8
After the top level, assemble the remain levels same way as the other side

9
Now it’s turn for the other lighting parts
Remove the shown 2x8 green plate at the front door of the house

Restore the green plate and pull the connector to the back of the model
Then assemble the lighting slopes around the model randomly
10
Get the 1x4 black lighting plate and the connect through the hole from the bottom
and assemble it with the removed green plate from last step

At last connect with the USB cable and it’s done
11
The lighting round plates from this set must be assembled here
The rest are assembled anywhere you like, just spread them equally to surround the
model