Glow Bricks Lego Star Wars Commander Cody Helmet 75350 User manual

Commander Cody
Helmet
1

First of all, separate the base to modify it by the 1x2 plates provided
2

3
Split the base as shown, detach the 1x8s and 1x10s on the side
Rearrange the base by putting the 1x8’s at the bottom with one 1x2 plate on each
side, the cover the top by the remain 1x2 and the 1x10

4
Assemble the white 1x4 lighting plate at the shown area
Then assemble the 1x2 and 1x10 plates on the base

5
Move the remain light to the upper area of the helmet, the wire could be hidden on
the side
Then assemble the spot lights at the expanded corners of the base

6
At last, place the 2 spot lights at the front corner and
connect the USB cable to power it up
Replace the white part in the red circle, remove the clear red tile from it and put on the
lighting part
Then you may power it up by the USB cable of the battery case
*Beware, if you powered by power bank with protection it might be turned off by
itself due to the power consume is too little, then you need to power by AC adaptor
or use the battery