Glow Bricks HarryPotter Hogwarts Express Collector's Edition Lego... User manual

Hogwarts Express
Collector’s Edition
1

2
Take the shown lighting parts for the platform

Remove the shown poles and assemble the lighting plates mentioned above
3
Check out the 1x2 at the end side of the set and assemble these five plates

Remove the shown tiles and the parts, then move the remain lighting plates to the top
and assemble them
4
Turn around the model and assemble the 2pcs of 1x8 lighting plates

Stick the 1x1 lighting tiles at the doorway like this and remember to place the
wires between the studs to avoid getting broken when restoring the tiles
5

Now restore the removed tiles
6

Turn back to the front side and assemble the led bulbs on the lamps
Take the white ball away, place the bulb on the black lamp stand and restore the ball
7

Now assemble the light for the last vehicle, take the lighting part with 2red plates
8

Before assembling, remove the top of the vehicle by the following way
And the installation will be started from the side in the red circle
9

Find the red lighting plate next the the connector and assemble it on the shown top
The direction must be same as the picture below
Restore the top, arrange the grey 1x4 plates to the seat side
And place the connector out of the train through the rear door
10

Assemble the black lighting plates on the black parts and restore the tops
11

After restoring the tops, assemble the remain red and black lighting plates to the end
The yellow lighting round plates will be assembled above the seats
Before that remove the black fences and the yellow round plates from the wall
12

Now assemble all 9pcs of lighting yellow round plates
Now combine the house, before that place the remain parts through the hole
except the brown 1x2 plates
13

Restore the black fences after the installation of yellow round plates is completed
Assemble the 3pcs of grey lighting plates to the removed windows then place them
back to the train
14

15
Now it’s turn for the middle vehicle, take the lighting parts with black plates only

Turn the vehicle upside down, remove the shown parts and assemble the lights
Place the wire in between the plates neatly
16

Move the remain 2lighting plates to the other side and restore the removed parts
Repeat the same procedure on the other side
17

At last, stable the wire at the bottom by the brown 1x3 plate as shown
18

Assemble the remain lighting parts
Remove the top of the rear side, and get the 1x6 lighing plate in the middle
Then split the remain lighting plates equally for both side
19

Assemble the 1x6 at the removed top
Arrange the connect to the back and the remain lights to the front
20