Glow Bricks Lego Dark Trooper Helmet 75343 User manual

Dark Trooper
Helmet
1

First of all, remove the helmet from the stand and split it as shown
2

3
Remove the 2x2 white plate from the eye and replace by the lighting part
After the installation the led bulb should be at the middle of the eye like the picture below

4
After the lights for both eyes are installed, restore them back to the helmet

5
To assemble the spot li ghts on the corners of t he stand, start by detaching the base
and modify it by the plates attached
Restore the whole helmet then put it back on the stand

6
Split the base as shown, detach the 1x8s and 1x10s on the side
Rearrange the base by putting the 1x8’s at the bottom with one 1x2 plate on each
side, the cover the top by the remain 1x2 and the 1x10

7
Restore the stand and assemble the lights, then you
may power it up by either USB or the battery case
Now you would get 2 extra studs extended from the corner to put the spot lights on
*Beware, if you powered by power bank with protection it might be turned off by
itself due to the power consume is too little, then you need to power by AC adaptor
or use the battery