Glow Bricks Lego CHEVROLET CORVETTE User manual

1

2
Start assembling the rear light, remove the shown parts first

3
Place the wires in between the lights properly make sure
they’re not placed on the studs then restore the parts
Replace the clear red parts on the brake lights by the lighting parts

4
Turn to the front side, remove the shown parts to assemble the lights at
the front
Turn the car upside down then place the wires at the bottom

5
Get the lights on one side through the hole beside the tires to get it
on the surface

6
Adjust the length, don’t make it too many wires disposed then
restore the parts to stable it
Place the wire connecting the light bulbs in between the studs

7
Put the inner side of the light cover, if there’s too much wire the
cover won’t be attached tight, you need to lift up the part on last
step and adjust the length. If it looks ok like the picture below you
can put the other cover back on
Now do the same thing for the other side

8
Restore the engine cover, and you should not see any cable
disposed then this part is done
The steps are basically same as the previous one

9
Remove the black plate at the bottom, place the wire in between
the studs to stable it then put the plate back

10
Remove the shown part on the side, place the wire in between the studs then put
the part back on
Assemble the red lighting plate as shown then put the top back on the car

11
Now gather three connectors at the rear side at the bottom
There’s a hole at the corner of the trunk to move the connector of
the rear light out
Put the removed parts back to the top

12
If you want to make the car convertible, you may place the lighting plate at
the bottom or you can take it away of course
Connect the plugs then you may light it up

13
Then connect with the plugs from the lights
If you want to power up by battery, you need to place the battery case inside the
trunk, remove the right rear bumper then place the connectors from the case
through the hole

14
Its pretty tight but I’m sure the case could be placed inside the trunk
After the plugs connected, place the battery case inside the trunk

15
Remove the shown parts if you want to put the hard cover with light on
Place the wire in between the red tile and the grey plate

16
Place the hard cover on the car, connect the cable to the battery case

17
Restore the cover and it’s done