Grandview EDGE R3 PE-L Series Instruction Manual

Vertical decorative frame (2pcs)
Corner
pFabric(1pc)
Hook(2pcs) love(2 pairs)
Plastic Corner Protection
12
34
Horizonatal Frame Connection
Step
Spring
Horizontal Frame
Connection Part
(pre-installed)
Connecting
Strengthen Plate
PE-LXXXXX(R3/R4)
M5x8
M5x8
Obround Nut Fastening Plate
The installation method of the inner frame: the four corners of the inner frame
are connected with the corner bracket, and then evenly distribute the round
screws to the corresponding holes to facilitate the installation of the fastening
plate and the hanging plate.
Placing and fastening the support bar to the center of longer frames
Vertical inner silver frame(2pcs)
Horizontal inner silver frame(4pcs)
Vertical decorative frame(2pcs)
Install inner silver frame

2
Knock into
the slot
slide in
1
GRANDVIEW CRYSTAL SCREEN CO., LTD.
Add: No. 43 South International Trade Avenue, Hualong Town, Panyu, Guangzhou, GuangDong, China
Web: www.grandviewscreen.com
Tel: [phone]
A=Total length*0.6mm
B=Total height-119mm
C=28mm
A
B
A
B
5- 7 mm C
M5x6
M5x8
Place the EPE foam at
the bottom firstly
Please keep the fabric to
remain flat while unfolding
Please keep the fabric from scratches
Install the Fabric
1.Place the EPE foam onto a flat ground and then roll out the fabric(facing down onto the EPE foam).
Align the assembled silver frame to the dotted lines of four sides of the fabric(very important).
2.Insert tension rods on the four sides edge of the fabric.
3.Align all the springs to the holes of fabric.
4.The springs need to vertically hook the tension rods in the corresponding screen holes.
Hanging on the wall
Install the decorative frames