HMN M2 El-tip User manual

User guide
M2 shower/commode chair with 24 inch wheels
How to mount the wheels:
The axel is clicked into the bush. Pull the wheel to make sure it is correctly
mounted.
But be careful not to tighten the bolts too much. Using the chair without the
driving belt, the wheels will get more elastic.
(when you receive the chair it is adjusted to the middle position in height)
How to adjust the height:
The bushings to the 24-inch wheels are taken off with a wrench key and moved to
the desired height.
The anti-tip bar Is moved to the same postion as the 24-inch wheels.
The clips holding the front wheels are taken out, and the front wheels are moved to
the desired height.
The front wheels can be pu in a position which is ONE (1) position different from the
25 inch wheels (if you want the chair to be slightly tilted)
All other adjustments shall be in the same position! (For example: in the top
hole). Double check that all nuts and bolts are tightened and that all the clips
are pressed in place.
Make sure to tighten the bolts well
Mount the brakes
For mounting:
2 x Brakes, 4 x washers and 4 x bolts
Mount the brake on the chair.
Mount the washers and bolts
Fasten the bolts
Adjusting the brakes
Loosen the bolts and move the brake so it has the wanted impact.
Tighten the bolts well!
Pan / bucket
When sliding the bucket of the chair, it is important to slide
it straight backwards, along the seat.
Otherwise, it can be very difficult to get the bucket of the chair.

WARNING
RISK OF ROLLING OR GLIDE-OUT!
TO AVOID THE CHAIR CAN ROLLS OR GLIDER IN TRANSFER,
TO ALL 4 WHEELS BE LOCKED!
ATTENTION!!
IF THERE IS A SMOOTH SURFACE,
THERE IS STILL A RISK OF THE CHAIR ROLLING OR GLIDING.
DO NOT SIT ON THE OUTER 10
CM OF THE SEAT THAT THE
CHAIR CAN TIP FORWARD.
DO NOT STAND ON THE
FOODRESTS
Check with proper intervals the fastening of the wheels to the leg.
2 Years complaint rights against manufacturing errors.
Terms of claim for frame.
HMN grants 5 years claim rights against frame break-down for all M2
Shower/commode chairs and stainless steel shower stools.
The warranty applies for production and material break downs, and can
only be used if the products have been in normal use.
Please note that the normal wear is not included in the warranty.
Cleaning:
The product can be cleaned with regular cleaning products without
non-abrasive detergent. Wash and dry the product after the
cleaning. The product can be washed up to 85° degrees in 3
minutes.
CE
This product is CE marked which means the product
complies with EU legislations and enables the free
movement of the product in the European market.
09.10.15
HMN a/s
Midtager 22, 2605 Brøndby, Denmark
Tel.: [phone] Fax. [phone]
E-mail [e-mail] www.hmn.dk
Footrests
Pushing the footrests aside:
Lift them and turn them to the side you want.
The plastic plate can be tipped up if you want to take them to take up very little space.
Height adjusting the footrests:
Adjust the height of the footrests by taking the clips out, placing the footrests in the
wished position, and last put the clips back again.