Hyco RAD15Y User manual

Product Instruction Manual
RAD15Y & RAD20TY
Riviera il filled radiator
Version 3.2 Jan 2015
V15.5/2
Riviera_Layout 1 31/05/2015 19:13 Page 1

2
Thank you for purchasing from the Hyco Riviera range of oil filled radiators.
Available in 1.5kW standard and 2.0kW timer models, the Riviera offers a
silent, gentle heating solution for light commercial and domestic use.
Please read and understand these instructions before commencing
installation, and leave them with the user when installation is complete.
1. Imp rtant safety p ints
• Do not carry the appliance by the supply cord.
• Do not let the supply cord hang over the appliance.
• The supply cord cannot be replaced by the user. If the cord is damaged the appliance
should be returned to the manufacturer or an authorised service agent for
replacement.
• Do not cover the appliance as it may cause overheating.
• Children of less than 3 years should be kept away unless continuously supervised.
• Children aged from 3 years and less than 8 years shall only switch on/off the
appliance provided that it has been placed or installed in its intended normal
operating position and they have been given supervision or instruction concerning
use of the appliance in safe way and understand the hazards involved. Children aged
from 3 years and less than 8 years shall not plug in, regulate and clean the appliance
or perform user maintenance.
• This unit should be installed at least 1.5m from baths, showers, laundries, swimming
pools etc.
• Some parts of this product can become very hot and cause burns. Particular attention
should be paid where children and vulnerable people are present.
• This heater is filled with a precise quantity of special oil. Repairs requiring opening of
the oil container are only to be made by the manufacturer or their service agent.
• Always ensure the castors are mounted to the bottom of the heater.
D N T TURN N THE HEATER IF IT IS UPSIDE D WN
• Always switch off the appliance when not in use.
Riviera_Layout 1 31/05/2015 19:13 Page 2

3
2. Installati n
Always ensure the castors are mounted to the bottom of the heater.
D N T TURN N THE HEATER IF IT IS UPSIDE D WN
• Remove all the packaging.
• Turn the heater upside down.
• Position the wheel mounting plates between the end two fins at both ends of
the heater, attach them using the U-bolt and wing nuts provided.
• Attach the castors to the plates using the nuts provided.
• Ensure all nuts are tightened and then return the heater to the correct way up.
• Allow the oil to return to the bottom of the unit before turning on, around two
minutes should be sufficient.
Riviera_Layout 1 31/05/2015 19:13 Page 3

3. Operati n
It is normal for there to be some smells and fumes on the first operation or after
a long period of not being used, this will disappear within a short period of use.
Basic perati n
1. Choose a suitable location for the
heater, ensure all the points in the
safety section of these instructions
have been followed.
2. Insert the plug into a suitable socket.
3. Turn the thermostat knob (A)
clockwise to its maximum setting.
4. Select a power setting from the
four available N settings (B).
0 = FF
I = Low (600/800W)
II = Medium (900/1200W)
III = High (1500/2000W)
5. nce the room temperature has reached
the desired temperature adjust the
thermostat setting down (anti-clockwise)
until a click is heard and the element
indicator light (C) goes out. This will now
maintain your current room temperature.
6. To turn the heater off simply return the
power selection knob to the 0 ( FF) position.
4
High Low
A
B
C
I
II
0
III
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
W
H
D inc. feet
D
Riviera_Layout 1 31/05/2015 19:13 Page 4

Timer perati n (RAD20TY)
1. To use the 24hr timer you should
select the operating mode by sliding
the switch in the centre of the timer
disk as follows:
I = n at all times
= Timed operation
0 = ff at all times
(In all modes the times will continue to keep
time whilst connected to the mains power supply).
2. To create your own schedule you should
move the slider to the position.
3. To set the time on the timer simply turn the outer timer disc until the arrow on
the centre timer disc points to the current time (24hr format).
4. The timer has a total of 24hrs marked on the outer disc and these are broken
down further by four individual segments that represent 15min intervals within
that hour. Push the desired segments out, away from the centre timer disc to
confirm you would like the heater to be on at the corresponding time. Repeat
this for each 15min interval the heater is required to operate.
5. To change the time to be off, push the segments in towards the centre timer
disc at the required intervals.
4. Maintenance
• Always isolate the appliance from the power supply before commencing
any maintenance and ensure the unit has completely cooled.
• Never use abrasive chemicals or materials to clean the unit.
• Clean the exterior of the unit using a soft, dry cloth.
5
High Low
A
B
C
I
II
0
III
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
W
H
D inc. feet
D
High Low
A
B
C
I
II
0
III
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
W
H
D inc. feet
D
High Low
A
B
C
I
II
0
III
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
W
H
D inc. feet
D
Riviera_Layout 1 31/05/2015 19:13 Page 5

5. Specificati ns
RAD15Y RAD20TY
Voltage 230v~50Hz
Power 1.5kW 2.0kW
Height (mm)* Width(mm) Depth(mm) Weight(kg)
RAD20TY 690 465 160 11.8
RAD15Y 690 385 160 9.8
*Depth excluding feet, depth including feet 240mm.
6
High Low
A
B
C
I
II
0
III
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
W
H
D inc. feet
D
Riviera_Layout 1 31/05/2015 19:13 Page 6

6. Guarantee and service p licy
This product is guaranteed against faulty materials and manufacture for a period of one
year from the date of purchase. Hyco will in its sole discretion replace, repair or refund
any faulty unit. Incorrect installation and failure to follow correct operating instructions
are excluded. Consequential costs such as labour charges or damage to surroundings
are expressly excluded.
7
Riviera_Layout 1 31/05/2015 19:13 Page 7

hyco.co.uk
Hyco Manufacturing Ltd
Normandy Court
Express Way
Castleford, WF10 5NR
T 01924 225 200
F 01924 225 210
E [e-mail]
INF RMATI N F R C RRECT DISP SAL F THE PR DUCT IN ACC RDANCE WITH THE
EUR PEAN DIRECTIVE 2002/96/E.
At the end of its working life this equipment must not be disposed of as household
waste. It must be taken to a local authority waste collection centre or to a dealer
providing this service. Disposing of electrical and electronic equipment separately
enables its components to be recovered and recycled to obtain significant savings in
energy and resources. In order to underline the duty to dispose of this equipment
separately, the product is marked with a crossed out dustbin.
Riviera_Layout 1 31/05/2015 19:13 Page 8