Hyco FH-201 User manual

HYCO MANUFACTURING LTD
FAN HEATER FH-201
Please read and understand t ese instructions before commencing installation and leave
t em wit t e user w en installation is complete.
1. SAFETY
1. This appliance meets the electromagnetic compatibility requirements specified in
EN55104/95 ith regard to interference ith radio and TV sets.
2. Only connect the fan heater to a single-phase socket ith a mains voltage as specified
on the rating plate.
3. Do not use the appliance in rooms less than 4m
2
area.
4. Do not leave the appliance s itched on hilst unattended. Ensure that the s itch is in
OFF (O) position and the thermostat is set to minimum.
5. Al ays unplug the appliance hen not in use. Do not use the cord to unplug the heater.
6. Keep combustible materials such as furniture, cushions, bedding, paper, clothes,
curtains etc at least 100cm a ay from the fan heater.
7. If all mounted, do not fix to combustible material such as ooden, synthetic or plastic
surfaces.
8. Do not hang anything on or in front of the fan heater.
9. Keep the air inlet and outlet grilles free from objects at least 1m in front and 50cm behind
the heater.
10. Do not install the heater directly belo a socket.
11. Do not let animals or children touch or play ith the fan heater. Please note that the air
outlet gets very hot during operation (more than 80°C or 175° F).
12. Do not cover the fan heater. If covered there is a risk of overheating.
13. Do not use the fan heater in the immediate surroundings of a bath, sho er or s imming
pool.
14. Do not operate the fan heater in explosive atmospheres or hilst using inflammable
solvents, varnish or glue.
15. If the cord of this appliance is damaged, discontinue use of this product and contact the
manufacturer for further instructions.
2. INSTALLATION
The appliance requires no installation; it should be used solely as a portable appliance. Please
note that portable appliances are not suitable for use in a bathroom.
3. OPERATION
Turn the thermostat knob in a clock ise direction until it reaches the maximum setting.
The fan heater has 3 po er settings:
Summer service (ventilation only): turn the knob to the fan setting.
Heating at reduced power (1000 ): turn the knob to setting I.
Heating at full power (2000 ): turn the knob to setting II.
To s itch the appliance off, turn the knob to setting O.
REGULATING THE THERMOSTAT:
When the room has reached the desired temperature, turn the thermostat knob in an anti-
clock ise direction just until the appliance s itches off and not beyond. The temperature ill then
be regulated and kept at a constant level by the thermostat.
T e eater is fitted wit a safety device w ic will switc off t e eater in case of
accidental over eating (please see safety notes). To reset, disconnect t e eater from t e
power source for a few minutes to allow t e unit to cool down. Make sure t at any causes
of over eating suc as obstructions to t e grilles are removed and plug t e appliance in
again.
Thermostat
Switch

4. GUARANTEE AND SERVICE POLICY
The FH-201 comes complete ith a standard 12 month arranty that protects against any
manufacturing defects up to 1 year of the original purchase date. In the event of a product failure
please contact Hyco on 01977 517555. Incidental or consequential damages are excluded from
this arranty.
Hyco Manufacturing Ltd
Units 1 & 2 Calder Works
Methley Road, Castleford
West Yorkshire, WF1 1NX
Tel: [phone] Fax: [phone]
Web: www.hyco.co.uk
E-mail: [e-mail]