Hyco Fiji FH-201Z User manual

Product Instruction Manual
Fiji
FH-201Z
2.0kW Fan heater
Version 3.2 Jan 2015
V15.6/2
FH-201Z_Layout 1 08/06/2015 16:00 Page 1

2
Thank you for purchasing the Fiji fan heater. The FH-201Z comes with a
thermostat and three heat settings. With its stylish letterbox design the Fiji
is suitable for a wide range of portable heating applications in the home
and office environment. Please read and understand these instructions
before commencing installation, and leave them with the user when
installation is complete.
1. I portant safety points
• nly connect the unit to a single phase supply with a mains voltage as specified
on the rating plate.
• Do not carry the appliance by the supply cord.
• The supply cord cannot be replaced by the user. If the cord is damaged the
appliance should be returned to the manufacturer or an authorised service agent
for replacement.
• The appliance must not be located immediately below an electrical socket outlet.
• Always keep the outlet and inlet grills clean.
• Do not cover the inlet or outlet as it may cause overheating.
• Children of less than 3 years should be kept away unless continuously supervised.
• Children aged from 3 years and less than 8 years shall only switch on/off the
appliance provided that it has been placed or installed in its intended normal
operating position and they have been given supervision or instruction concerning
use of the appliance in safe way and understand the hazards involved. Children
aged from 3 years and less than 8 years shall not plug in, regulate and clean the
appliance or perform user maintenance.
• Do not use this heater in the immediate surroundings of a bath, a shower or
a swimming pool.
• Do not use this heater with a programmer, timer, separate remote control system
or any other device that switches the heater on automatically, since a fire risk exists
if the heater is covered or positioned incorrectly.
FH-201Z_Layout 1 08/06/2015 16:00 Page 2

3
• Do not use the heater on deep pile carpets or rugs; ensure that there is no
overhanging surface within 75cm of the outlet grille.
• Do not use in the vicinity of any combustible materials, curtains or other furnishings.
2. Installation
The appliance must not be located immediately below an electrical socket outlet.
Do not use this heater with a programmer, timer, separate remote control
system or any other device that switches the heater on automatically, since
a fire risk exists if the heater is covered or positioned incorrectly.
This heater is intended solely as a portable appliance; only operate using the power cord
and 13 amp plug supplied.
If the plug needs changing, make the connections as:
➢Brown / Red: L
➢Blue / Black: N
➢Green / Yellow: E
FH-201Z_Layout 1 08/06/2015 16:00 Page 3

3. Operation
Fully uncoil the power cord before plugging the heater in
Choose from three heat settings:
• Fan only (cool)
• 1.0kW (half power)
• 2.0kW (full power)
Select the maximum heat setting from the thermostat dial. nce the desired room
temperature is achieved adjust the dial down until a click is heard and the element
light goes off. This will now maintain the current room temperature.
Safety cut-out
In the event of a safety cut-out operation, the heater will blow cold air until the
temperature drops low enough for the thermal cut-out to close once again. The cause
of the overheating should be established before continuing to use the heater.
4
FH-201Z_Layout 1 08/06/2015 16:00 Page 4

4. Maintenance
Always isolate the appliance from the power supply before commencing
any maintenance.
Never use abrasive chemicals or materials to clean the unit.
• Clean the exterior of the unit using a soft, dry cloth.
5
FH-201Z_Layout 1 08/06/2015 16:00 Page 5

6
280mm
270mm
130mm
5. Specification
Voltage 230v~50Hz
Power ( ax) 2000W
Weight 1.4kg
FH-201Z_Layout 1 08/06/2015 16:00 Page 6

6. Guarantee and service policy
This product is guaranteed against faulty materials and manufacture for a period of one
year from the date of purchase. Hyco will in its sole discretion replace, repair or refund
any faulty unit. Incorrect installation and failure to follow correct operating instructions
are excluded. Consequential costs such as labour charges or damage to surroundings
are expressly excluded.
7
FH-201Z_Layout 1 08/06/2015 16:00 Page 7

hyco.co.uk
Hyco Manufacturing Ltd
Normandy Court
Express Way
Castleford, WF10 5NR
T 01924 225 200
F 01924 225 210
E [e-mail]
INF RMATI N F R C RRECT DISP SAL F THE PR DUCT IN ACC RDANCE WITH THE
EUR PEAN DIRECTIVE 2002/96/E.
At the end of its working life this equipment must not be disposed of as household
waste. It must be taken to a local authority waste collection centre or to a dealer
providing this service. Disposing of electrical and electronic equipment separately
enables its components to be recovered and recycled to obtain significant savings in
energy and resources. In order to underline the duty to dispose of this equipment
separately, the product is marked with a crossed out dustbin.
FH-201Z_Layout 1 08/06/2015 16:00 Page 8