LuxaFlex Aluminium Venetians User manual

Aluminium Venetians
The information and advice included in this brochure has been
prepared with care. However, we are unable to accept responsibility for
the results of or any damage caused during operation.
As with all metal-based products, Luxaflex®Aluminium Venetians can
be subject to some variations in the slat finishes, and are considered
normal, acceptable quality. Precautions should be taken to reduce
exposure to harsh environmental elements, such as salt air. Even
though Luxaflex Aluminium Venetians are made with a unique clutch
system, preventing damage to the tilt mechanism caused by over
winding the tilt wand, care during operation must still be taken.
® Somfy is a registered trademark of Somfy SAS. © Copyright 2017 Hunter Douglas
Limited [ABN 98 009 675 709]. ® Registered Trade Marks of Hunter Douglas Limited.
18.018.016 [02/2018]
luxaflex.com.au
Welcome to the
Luxaflex lifestyle
Thank you for purchasing Luxaflex®Aluminium
Venetians. With proper operation and
care your new blinds will provide years of
beauty and performance. Please review this
instruction booklet thoroughly for operation
and care information.

LiteRise operation
To lower and raise the blind:
Simply use the handle to push up to raise the blind and
pull down to lower the blind.
To tilt the slats:
Use the same motion on the handle to tilt the slats to the
desired position.
Cord cleat operation
To tilt the slats:
Pulling on one of the single cords will tilt the slats in one
direction, and pulling the other cord will tilt the slats in
the opposite direction.
To lower the blind:
To lower, simply pull the cord towards the centre of the
blind and lower gently.
To raise the blind:
To raise, tilt the slats to the fully opened position.
Remove the bottom rail from the hold-down brackets
(iffitted). Pull the lift cord towards the centre and raise
the blind. To lock in position simply move the cord
towards the outer edge of the blind to engage the
cordlock.
Motorised operation
For motorisation information, please refer to SOMFY®
product brochure that is supplied with your blinds.
Care and cleaning
Dust can be easily brushed off at regular intervals using
a clean soft cloth, a feather duster or a vacuum cleaner
with brush attachment.
Routine maintenance
Dusting
To dust, tilt the slats up and then down to reach the
entire top and bottom surfaces.
Vacuuming
To vacuum, use the brush attachment and tilt
slats up and then down to reach the entire top and
bottom surfaces.
Wiping
Slats may be wiped over with warm water and a
milddetergent.
Operation
Duo-ex®operation
1. Lower the blinds.
2. Twist the wand to operate the opening and closing
ofthe slats.
3. Twist the wand to the right to close all of the slats.
4. Twist the wand to the left to vary the opening of
theslats.
5. If a different height or opening of blind desired, repeat
steps 2 to 4.
Cord and wand operation
To tilt the slats:
Simply rotate the wand to tilt the slats from fully closed
to any desired angle.
To lower the blind:
To lower, simply pull the cord towards the centre of the
blind and lower gently.
To raise the blind:
To raise, tilt the slats to the fully opened position.
Remove the bottom rail from the hold-down brackets
(iffitted). Pull the lift cord towards the centre and raise
the blind. To lock in position simply move the cord
towards the outer edge of the blind to engage the
cordlock.