MacDon FD75 User manual

The harvesting specialists worldwide.
FD75
FlexDraper®Combine Header
Operator’s Manual
169595 Rev. D
Original Instruction
epcatalogs.com

FD75 FlexDraper®FlexDraper®Header for Combines
Published: October, 2013
epcatalogs.com

Declaration ofConformity
169595 iRev. D
epcatalogs.com

Introduction
This instructional manual contains information on the FD75 FlexDraper®and the CA25 Combine Adapter. It must
be used in conjunction with your combine operator's manual.
TheFD75FlexDraper
®is specially designed as a “straight cut” header and is equipped to work well in all straight
cut conditions, whether cutting on or above the ground, using a three-piece flexible frame to closely follow ground
contours.
CAREFULLY READ ALL THE MATERIAL PROVIDED BEFORE ATTEMPTING TO UNLOAD, ASSEMBLE, OR USE
THE MACHINE.
Use this manual as your first source of information about the machine. If you follow the instructions given here,
your header will work well for many years. If you require more detailed service information, a technical manual is
available from your MacDon Dealer.
The Table of Contents and Index will guide you to specific areas of this manual. Study the Table of Contents to
familiarize yourself with how the information is organized.
Keep this manual handy for frequent reference and to pass
on to new Operators or Owners. A storage case for this
manual is located inside the header left endshield.
Call your MacDon Dealer if you need assistance,
information, or additional copies of this manual.
Figure 1: Manual storage location
169595 iiRev. D
epcatalogs.com

Model and Serial Number
Record the model number, serial number, and model year of the header, combine adapter, and Slow Speed
Transport/Stabilizer Wheel option (if installed) on the lines below.
NOTE: Right Hand (RH) and Left Hand (LH) designations are determined from the operator’s position,
facing forward.
Draper Header
Header Model:
Serial Number:
Year:
In shipping configuration, the serial number plate
is located beside the knife drive motor on the left
hand endsheet.
Figure 2: Header serial number location
Combine Adapter
Adapter Model:
Serial Number:
Year:
The serial number plate is located on the underside of
the reservoir at the right end.
Figure 3: Adapter serial number location
Slow Speed Transport/Stabilizer Wheel Option
Serial Number:
Year:
The serial number plate is located on the right hand
axle assembly.
Figure 4: Slow Speed Transport/Stabilizer
Wheel Option serial number location
169595 iii Rev. D
epcatalogs.com

Buy now
MacDon FD75 FlexDraper Combine Header Operators Manual PDF
With Instant Download