System View Wall Mount
SP-6110/6112/6118
10.4”/12.1”/8.4” Fanless Panel PC
All Rights Reserved. Copyright 2013
Safety Precaution
LAN1 LAN2 USB VGA COM1 COM2 VCC GND
SP-6110 SP-6112
SP-6118
SP-6110 SP-6112 SP-6118
Cut-out Dimension:
(Unit: mm)
SP-6110
213.2 ± 0.25
204.8 ± 0.5
253.6 ± 0.5
262 ± 0.25
8 - Ø4.5
Wall
SP-6112
230 ± 0.25
222 ± 0.5
308 ± 0.25
300 ± 0.5
100 ± 0.25
10 - Ø4.5
Wall
SP-6118
172.2 ± 0.25
164 ± 0.5
228.7 ± 0.25
219.5 ± 0.5
76.2 ± 0.25
Ø3.5 x 10
Wall
CAUTION! Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent
type recommended by the manufacturer. Dispose of used batteries per the manufacturer’s instructions.
WARNING! Some internal parts of the system may have high electrical voltage. Therefore we strongly
recommend qualified engineers open and disassemble the system. The LCD and touch screen are easily
breakable, please handle them with extra care.
The following messages are safety reminders on protecting your system from damages and
extending a long life of the system.
1. Check the Cable Voltage
● The range of operating voltage should be between DC 9V and 36V. Otherwise, the system
could be damaged.
2. Environmental Conditions
● Place your SP-6110/6112/6118 on a sturdy & level surface. Be sure to allow enough space
to have easy access around the system.
● Avoid extremely hot or cold place to install the system.
● Avoid exposure to sunlight for a long period of time or in a airtight space. Also, avoid the
system from any heating device or using SP-6110/6112/6118 when it's been left outdoors
in a cold winter day.
● Avoid moving the system rapidly from a hot place to a cold one and vice versa because
condensation may come from inside of the system.
● Place SP-6110/6112/6118 in strong vibrations may cause hard disk failure.
● Do not place the system close to any radio active device in case of signal interference.
3. Handling
● Avoid putting heavy objects on top of the system.
● Do not turn the system upside down. This may cause the floppy drive and hard drive to
mal-function.
● If water or other liquid spills into this product, unplug the power cord immediately.
4. Good Care
● When the outside of the case is stained, remove the stain with neutral washing agent with
a dry cloth.
● Never use strong agents such as benzene or thinner to clean the system.
● If heavy stains are present, moisten a cloth with diluted neutral washing agent or alcohol,
and then wipe thoroughly with a dry cloth.
● If dust has been accumulated on the outside, clean with a special vacuum cleaner made
for computers.
