quadient IS-300 Series Parts list manual

Machine components:
1
7 98
5
Caution: Product weighs 10.8kg,
please seek assistance before lifting
3
Please do not connect your replacement
machine to the power until step N6
The machine must be disconnected from the
power supply before continuing to the next step!
1 42
Remove the Meter (f)
IS-300 SeriesBase
Product Replacement Guide Average Time Required: 20 minutes
Slide the Meter (f) towards you
N1. Remove the components from youroriginal machine
Machine Base
Open the door of the compartment situated to the
left of the Ink Cartridge (e) to revealthe Meter (f)
Feed Table
Disconnect the LAN Cable (c) from the left hand
side by pressing and holding down the clip
LAN Cable
Remove replacement unit from box & place
original unit back into box ready for collection
N2. Unpack your replacement
Power Cable Ink CartridgeMeter
Removal
Disconnect the Power Cable (d) from the right hand
side of the machine
Installation
Lift the top cover to reveal Ink Cartridge (e)
and Meter (f) compartment
Press down on the Cartridge (e) below the word
‘TOP’ until you hear a ‘click’
Remove the Ink Cartridge (e) and close the
machine cover
Remove the Feed Table (a) by lifting the machine
(b) slightlyandsliding the Feed Table downwards
to unlock
66

321
N3. Insert the Meter N4. Install the Cartridge
IS-300 SeriesBase
Product Replacement Guide - Continued
To finishthe replacement process the machine will now need to connect to our server. Please:
N8. Make a connection
2
Press Select ‘ONLINE SERVICES’ & press
Choose ‘GENERIC CALL’ & press
Press when the callhasfinished
Press key
1
Press Choose ‘AUDIT CALL’
Press and again to confirm
Press when the call has finished
Press key
N5. Attach your Feed Table
snoitalutargnoC
Your machine is ready to use!
For more information orif you experience
any issuesplease visit: kb.quadient.co.uk
Lift the top cover to revealInk Cartridge
location (e)and Meter compartments (f)
Openthe door of the compartment
situated to the left of the Ink Cartridge (e)
Place the Meter (f) into the
Meter compartment
Lift machine (b) slightly on the left hand side and align
the hooks to attach the Feed Table (a)
Turn onthe machine using the switch behind
the Power Cable (d)
1
Push the Meter (f) back until it slots
into position and close the door of
the compartment
4
Insert the Ink Cartridge (e) at anangle
into the machine with the ‘TOP’ and
‘LOCK’ stickers facing upwards
1
Push the Ink Cartridge (e) towards the
back of the machine until you hear a
‘click’- close the cover of the machine
2
N6. Connect yourCables
Re-connect the LAN Cable (c) and Power Cable (d) to either side of the machine
1
N7. Switch on the machine
1st Inl. Lett
No service
11.02.16
£000.00
00000g
E
S
Mem:
The home screen should be displayed as shown.
If you have departments on your machine you will
need to select a department and enter your PIN
code if necessary
2
1
A0077958/B 17/03/2020