RIGHT ANGLE 52431 User manual

Read all the instructions before beginning.
Page1 OF 2
Version Dated: 3/27/15
Instruction # 52798
K&A Manufacturing
Hardware Pack # 52431
6703 Zinser Street
Schofield, WI 54476
Phone: [phone]
Fax: [phone]
www.raproducts.com
Floating Modesty Panel

4
4
1
2
3
Step 2: With the help of an assistant, place
the modesty panel 1at the desired location.
It should normally be centered left to right
and away from objects on the underside of
the worksurface that could interfere with the
panel.
Important Note: The worksurface
material must be compatible with the
screws provided. The worksurface must
be at least 1" thick.
Step 3: Attach the modesty panel to the
underside of the worksurface with (3) wood
screws 4in each bracket and fully tighten.
No pilot holes are provided.
Center bracket
only provided on
60" or wider
modesty panels.
A
Page 2 OF 2
K&A Manufacturing
6703 Zinser Street Schofield, WI 54476
Phone: [phone]
Fax: [phone]
www.raproducts.com
Tools Required for Assembly:
Power Driver W/Adjustable Torque
#2 Phillips Head Driver Bit or
#2 Square Head Driver Bit
Hardware Pack # 52431
Drawn Actual Size
ITEM # PART # DESCRIPTION QT .
1 Varies Laminate 3/4" Modesty Panel 1
2 800119 Floating Modesty Panel Bracket Right Varies
3 800248 Floating Modesty Panel Bracket Left Varies
4 51708 M5 x 18mm (7/8") Sq/Ph/Wshr Head Wood Screw 18
Instruction # 52798
51708
Detail A
Step 1: Lay the modesty panel 1on a protected surface
with the pilot holes facing up. Align the holes on the
long side of the modesty panel brackets 2and 3with
the pilot holes in the panel. Attach the brackets to the
modesty panel with (3) wood screws 4in each bracket.
Do not over-tighten the screws. Use a low torque setting
on the power driver. There will be (3) brackets on
modesty panels 60" wide or wider.