rollease acmeda Zipscreen Extreme User manual

Page 1of 14
Zipscreen Extreme Installation Manual | v4.2| August 2019
2019 ©Copyright All Rights Reserved Rollease Acmeda
ZIPSCREEN EXTREME
INSTALLATION MANUAL
PART A - BRACKET INSTALLATION
BOX 190 –INSTALL BRACKET TO WALL /CEILING USING APPROPRIATE FIXINGS TO SUIT APPLICATION
Face Fix
USE HOLES IN BRACKET AS GUIDE
Side Fix
USE PRE-DRILLED HOLES IN BRACKET AS GUIDE
Top Fix
USE HOLES IN BRACKET AS GUIDE
NOTE:
Ensure brackets are aligned and level. Measure brackets end to end to confirm measurement is correct.

Page 2of 14
Zipscreen Extreme Installation Manual | v4.2| August 2019
2019 ©Copyright All Rights Reserved Rollease Acmeda
OPEN BRACKETS –INSTALL BRACKET TO WALL /CEILING USING APPROPRIATE FIXINGS TO SUIT APPLICATION
Face Fix
Side Fit
Top Fix
NOTE:
Ensure brackets are aligned and level. Measure brackets end to end to confirm measurement is correct
----------------------------------------------------------------------------------------------------------------------------------

Page 3of 14
Zipscreen Extreme Installation Manual | v4.2| August 2019
2019 ©Copyright All Rights Reserved Rollease Acmeda
PART B - BLIND INSTALLATION FOR OPEN BRACKET & BOX 190
STEP 1 –TEMPORARILY REMOVE SCREW FROM ZAMAK ADAPTOR LOCKING RING
STEP 2 –TEMPORARILY REMOVE NUT AND BOLT FROM IDLER ADAPTOR
STEP 3 –MOUNT MOTOR END TO BRACKET

Page 4of 14
Zipscreen Extreme Installation Manual | v4.2| August 2019
2019 ©Copyright All Rights Reserved Rollease Acmeda
STEP 4 –MOUNT IDLER END TO BRACKET
STEP 5 –SECURE RETAINING SCREW OF ZAMAK ADAPTOR LOCKING RING
Step 6 –RUN BLIND DOWN

Page 5of 14
Zipscreen Extreme Installation Manual | v4.2| August 2019
2019 ©Copyright All Rights Reserved Rollease Acmeda
STEP 7 –ADJUST FABRIC SO THAT IT IS CENTRED WITH SYSTEM
Step 8 –TEST BLIND OPERATION
Ensure wiring is correct and motor is operating correctly.
----------------------------------------------------------------------------------------------------------------------------------------------------------------------
PART C –SIDE GUIDE INSTALLATION FOR OPEN BRACKET & BOX 190
STEP 1 –MOUNT FIXING RAIL TO WALL ON BOTH SIDES (FOR FACEFIT APPLICATIONS ONLY)

Page 6of 14
Zipscreen Extreme Installation Manual | v4.2| August 2019
2019 ©Copyright All Rights Reserved Rollease Acmeda
STEP 2 –ALIGN U MOUNTING RAIL INTO BRACKET CUT-OUT AND MOUNT TO FIXING RAIL

Page 7of 14
Zipscreen Extreme Installation Manual | v4.2| August 2019
2019 ©Copyright All Rights Reserved Rollease Acmeda
STEP 3 –REMOVE STOPS FROM THE FUNNEL IN THE INNER RAILS
Use a flat head screwdriver to pry both stops out.
STEP 4 –SWING INNER RAIL INTO THE U MOUNTING RAIL ON AN ANGLE
NOTE: Repeat on opposite side.
STEP 5 –SECURE STOPS BACK INTO FUNNEL

Page 8of 14
Zipscreen Extreme Installation Manual | v4.2| August 2019
2019 ©Copyright All Rights Reserved Rollease Acmeda
STEP 6 –RUN BLIND UP AND DOWN TO ALLOW INNER RAIL TO MOVE INTO NATURAL POSITON
NOTE: The inner rails should sit parallel with the zip to avoid strain or jamming of the blind during operation. Ensure the zip is
running inside the inner rail on both sides.
----------------------------------------------------------------------------------------------------------------------------------------------------------------------
STEP 7 –SECURE INNER RAILS TO THE U MOUNTING RAIL

Page 9of 14
Zipscreen Extreme Installation Manual | v4.2| August 2019
2019 ©Copyright All Rights Reserved Rollease Acmeda
STEP 8 –MOUNT SECOND FIXTURE INTO THE U-MOUNTING RAIL
Run blind down and secure the Inner Rail at the bottom of the blind on both sides.
STEP 9 –FIX REMAINING SIDE GUIDE SCREWS AND SECURE
STEP 10 –TEST OPERATION AND APPERANCE OF BLIND
Check the Inner Rails are level and parrallel

Page 10 of 14
Zipscreen Extreme Installation Manual | v4.2| August 2019
2019 ©Copyright All Rights Reserved Rollease Acmeda
Run the blind down.
STEP 10 –TEST OPERATION AND APPERANCE –BOX 190
Check the Inner Rails are level and parallel.
Run the blind down

Page 11 of 14
Zipscreen Extreme Installation Manual | v4.2| August 2019
2019 ©Copyright All Rights Reserved Rollease Acmeda
STEP 11 –BOX 190 FRONT COVER FIXING
OPTIONAL FIXING POINTS DEPENDING ON INSTALLATION
----------------------------------------------------------------------------------------------------------------------------------------------------------------------

Page 12 of 14
Zipscreen Extreme Installation Manual | v4.2| August 2019
2019 ©Copyright All Rights Reserved Rollease Acmeda
SECTION 3 –TROUBLESHOOTING

Page 13 of 14
Zipscreen Extreme Installation Manual | v4.2| August 2019
2019 ©Copyright All Rights Reserved Rollease Acmeda

Page 14 of 14
Zipscreen Extreme Installation Manual | v4.2| August 2019
2019 ©Copyright All Rights Reserved Rollease Acmeda