Steelcase Context Firmware update

Steelcase, Inc.
Grand Rapids, MI 49501
U.S.A.
1-888-783-3522
Tools
Assembly Directions Printed In U.S.A.
REV
93-9504014 A
Page 1 of 4
This assembly direction shows installation of the Base Power-in into a utility trunk,
boundary wall is typical.
IMPORTANT: Do not assemble this product until you have read the supplementary Assembly
Directions outlining specifications and safety standards necessary to the safe use for this product.
This power system must be earthed (grounded)!
All electrical installations should be done by a
qualified person in accordance with codes and
regulations applicable at the installation site.
International Base Power-InContext®
(With Circuit Breakers)

Assembly Directions
93-9504014 REV APage 2 of 4
1. Remove access plate.
2. Remove closure plate from access plate.
3. Attach base power-in mounting bracket
to receptacle mounting bracket.
BASE POWER-IN
MOUNTING BRACKET
SERRATED PAN HEAD
TAPPING SCREWS (2)
BLUNT TIP
ACCESS PLATE
CLOSURE PLATE
ACCESS PLATE

4. Position access plate. Do not attach at this time! Thread base
power- in extender cables through receptacle opening, and
connect to power distribution blocks. (See power distribution legend )
Power Distribution Block Legend
Block Color Circuit
Black
Blue
White (optional)
Power
Power
Dedicated
Assembly Directions
93-9504014 REV APage 3 of 4
BASE POWER-IN
ASSEMBLY ACCESS PLATE
POWER DISTRIBUTION
BLOCKS
5. Mount base power-in.
a. Position and replace access plate.
b. Clip base power-in housing over top
edge of access plate.
c. Secure base power-in housing to base
power-in mounting bracket. BASE
POWER-IN
ASSEMBLY
SERRATED PAN HEAD
TAPPING SCREWS (2)
BLUNT TIP
ACCESS
PLATE
MOUNTING
SCREW

6. Assemble base power-in cover.
Assembly Directions
93-9504014 REV APage 4 of 4
BASE POWER-IN COVER
7. Connect base power-in cord sets to building power supply.
SERRATED PAN HEAD
TAPPING SCREWS (2)
BLUNT TIP
BASE POWER-IN
CORDSET
IMPORTANT: Base power-in cordsets are color
coded with tape according to their circuit usage.
(see legend in step 4.) They must be plugged
directly into the building power supply.
BRITISH ONLY:
Maximum current not to exceed
10 A for each fused plug.