Steelcase 9000 Series User manual

Steelcase, Inc.
Grand Rapids, MI 49501
U.S.A.
1-888-783-3522
Tools
Assembly Directions Printed In U.S.A.
REV
93-9501200 A
Page 1 of 6
Series 9000® Installation Of A “V-1” Pedestal
Under An Improved Worksurface
PEDESTAL HANGER
BRACKET ASSEMBLY
PEDESTAL HANGER BRACKET

Assembly Directions
93-9501200 REV A Page 2 of 6
1. Turn worksurface unit upside down. Turn key to the unlocked position. Position hanger bracket assembly so the
lock pin can be inserted into lock channel slot. Loosely secure to worksurface with (3) hex head screws.
HEX HEAD SCREWS
LOCK PIN
HANGER BRACKET
ASSEMBLY
LOCK CHANNEL SLOT
WORK SURFACE
TURN KEY TO
UNLOCKED POSITION

Assembly Directions
93-9501200 REV A Page 3 of 6
2. Place pencil mark on actuator rod guide above center of lock
rod spring. Remove hanger bracket assembly from work surface.
ACTUATOR ROD GUIDE
PENCIL MARK LOCK ROD SPRING

Assembly Directions
93-9501200 REV A Page 4 of 6
3. Insert pedestal lock pin into hanger bracket assembly slot. Secure with (2) hex head bolts. Pinch spring together
and slide over until center of spring is above pencil mark on actuator rod guide. While adjustment is being made,
make sure lock tab is parallel to side of pedestal. Remove hanger bracket assembly from pedestal and re-assemble
back onto underside of worksurface and tighten attaching screws.
HANGER BRACKET
ASSEMBLY SLOT
HEX HEAD BOLT
PEDESTAL LOCK PIN
LOCK
TAB
PENCIL MARK ON
ACTUATOR ROD GUIDE
LOCK ROD SPRING
HANGER
BRACKET
ASSEMBLY
HEX
HEAD
SCREWS

Assembly Directions
93-9501200 REV A Page 5 of 6
4. If your unit has a back panel please refer to Steelcase Installation
Direction 93-9501201-E. Position pedestal hanger bracket tight
against unit end panel. Punch a 1/8” dia. hole into worksurface
support with an awl. Secure in place with (1) screw.
5. Punch (3) 1/8” dia. holes into worksurface and secure
with (3) screws. End hole is not used when next to an
end panel. This step is typical to step 4.
HANGER BRACKET
BACK PANEL
PUNCH 1/8” DIA
HOLE USING AN AWL
HANGER BRACKET
HANGER
BRACKET
SCREW
#10 x 1/2”
END
HOLE