Steelcase TS Series User manual

Page 1 of 4
939503297 Rev B
TS Series Under-Worksurface Pedestal
CAUTION
unloaded
loaded
#2 Square Drive
If you have a problem, question, or request, call
your local dealer, or Steelcase Line 1 at
888.STEELCASE (888.783.3522)
for immediate action by people who want to help you.
(Outside the U.S.A., Canada, Mexico, Puerto Rico,
and the U.S. Virgin Islands, call: 1.616.247.2500)
Or visit our website: www.steelcase.com
©2012 Steelcase Inc.
Grand Rapids, MI 49501
U.S.A.
Printed in U.S.A.
®

Page 2 of 4
939503297 Rev B
Removal of Box and File Drawers
1. Pull drawer forward from the pedestal.
2. Push tab on each side of the drawer rail.
3. Remove drawer completely.
4. Push slide rails back into pedestal.
TIP: Mark all drawers so they can be easily
re-installed in their original positions.
SLIDE 2
1
DEPRESS QUICK-
RELEASE TAB
®

Page 3 of 4
939503297 Rev B
Installing the Worksurface
1. Place worksurface onto the pedestal.
2. Attach worksurface to pedestal by fastening four (4) 1" pan
head screws (supplied) through the pedestal body and mount to
the bottom of the worksurface.
NOTE: The front edge of the worksurface overhangs the front of
the pedestal by approximately 1/8".
3. Adjust pedestal glides until worksurface is level when finished.
NOTE: Pedestal filler available to fill gap between back of
pedestal and front of panel.
1
1/8"
NOTE: Worksurface to be
positioned approximately
1/8" from the front of the
pedestal.
1" PAN HEAD
SCREWS
3
2
®

Drawer Re-Assembly
NOTE: Remember to re-install drawers in their
original positions.
1. Verify that drawer rails are pushed back into
pedestal.
2. Pull ball cages on drawer rails to front of
drawer rails.
3. Carefully align drawer portion of rail with ball
cage of pedestal portion of rail and gently push
drawer back into pedestal.
TIP: Failure to re-assemble drawers correctly
may damage rails, rendering them non-functional.
1
2
Page 4 of 4
939503297 Rev B
3
®