Swisher PowerBlade PBS-4550 User manual

PBS-4550
Suzuki Models
Eiger 02-04
Vinson 02-07
500 Quad Runner 02 & Older
May fit additional models see Master List
Front
Caution: Do not exceed 5 MPH with the blade or it’s brackets installed
Remove the mount plate for trail riding where extra ground clearance is needed
1602 Corporate drive
P.O. Box 67
Warrensburg, MO 64093
1-877-627-5860
12980
Partial Frame Illustration

Item # Description Part #
7 Strap Bar 10474TK
8 Tube Clamp 10475TK
9 Strap Guide 10481TK
10 Carriage Bolt 5/16-18 X1 10197
11 Nylock Nut 5/16-18 NB181
12 Carriage Bolt 5/16-18 X2 NB590
13 Spacer 7825Z
Assembly Instructions
Note. Right and Left direction are from the operator position. The lower skid plate, If so equipped, may need
to be removed. Please retain plate and hardware to be reinstalled if the plate is removed.
Blade Mount Kit
1. Separate and Identify the parts to the Blade Mount and the Manual Lift Strap Guide.
2. Left side, Remove the two bolts at the frame just below the left footrest. Place the Left Hand Bracket
against the frame and reinstall bolts using the new longer bolts and lock washers provided.
3. Repeat with the Right hand side.
4. Tighten the bolts securely. Retain the old bolts for replacement if brackets are removed.
Manual Lift Strap Guide
1. For easier installation, you may want to remove the plastic front panel
2. Attach the Strap Bar to the front bumper supports using the C Clamps, Carriage bolts, spacers and
nuts. Note: adjust the height to allow Strap Guide to pass thru the opening in the plastic cover.
3. Attach the Strap Guide to the strap bar with the carriage bolts and nuts as illustrated.
4. Tighten all hardware then replace the front panel.
5. Route the lift strap through the oval opening after attaching it to the front Rack.
Item # Description Part #
1 Right Side Mount Plate 10470TK
2 Left Side Mount Plate 10471TK
3 Lock Washer 10146
4 Bolt M10 10304
5 Hair Pin #39 NB127
6 Clevis Pin 10305
1
2
3
4
5
6
7
8
9
10
11
12
13
Bumper Support Tube