U-Line H-1130 User manual

PAGE 1 OF 2 0715 IH-1130
πH-1130, H-3476
BULK SOAP DISPENSERS
1-800-295-5510
uline.com
INSTALLATION
OPENING THE DISPENSER
1. To open the dispenser lid, insert key into slot at back,
right side of lid and push in on key. (See Figure 1)
2. Back lid will pop off. (See Figure 2)
GENERAL MOUNTING INSTRUCTIONS
• Use the included tape on glazed tile, painted metal
or unpainted metal walls. Tape will not perform
satisfactorily if wall surface is porous like brick or
wood.
• On all other wall surfaces, use screws and anchors
(not included) or other appropriate hardware based
on surface type.
• Locate dispenser above a sink or counter.
Recommend never locating where spillage can fall
on floor creating hazardous conditions.
• Installer will be held responsible for proper
installation.
• To be in compliance with ADA regulations, the
dispenser should be mounted no more than 48"
from the ground.
MOUNTING WITH DOUBLE-SIDED TAPE
1. Thoroughly clean wall surface and let dry
completely. For silicone build-up, use a pumice-
type cleaner or grout cleaner to clean the surface.
2. Peel off paper from back of tape (supplied). Press
dispenser firmly to the wall and hold for at least 30
seconds to make sure tape has completely adhered
to the wall. (See Figure 3)
3. Wait 24 hours before filling with soap to ensure that
the tape has completely adhered to the wall before
adding weight.
MOUNTING WITH SCREWS
AND ANCHORS (NOT INCLUDED)
1. Remove lid (as described previously). Push latch out
and detach dispenser from back plate.
(See Figure 4)
2. Using the back plate as a template, mark hole
locations on wall.
3. Drill 3/16" diameter holes for anchors and screws or
other hardware. Attach dispenser to back plate and
replace lid.
Figure 1
Figure 3 Figure 4
Figure 2

PAGE 2 OF 2 0715 IH-1130
FILLING
MAINTENANCE
MAINTENANCE INSTRUCTIONS
It is important to clean and maintain the dispenser on a
regular, scheduled basis. Failure to do so can result in
dispenser malfunction.
• Open dispenser. Flush tank and pump mechanism
with warm water to remove residue and
contaminate. Refill with new soap and replace lid.
(See Figure 5)
• Cleaning all touch-points on dispenser with a
disinfectant should be part of a regular cleaning
schedule. (See Figure 6)
• Periodically give the dispenser an overall cleaning.
All internal and external parts should be cleaned
thoroughly.
CAUTION! Never use abrasive cleaners when
cleaning soap dispensers.
FILLING INSTRUCTIONS
CAUTION! For dispenser to work properly, use
foam soap only for foaming soap dispensers
and liquid soap only for liquid soap dispensers.
Foam soap dispensers handle foam soaps
from 0-14 centipose (cps).
1. Remove lid (as described previously).
2. Fill with appropriate soap and replace lid.
3. Priming the dispenser will take 6-10 strokes.
DISCLAIMER: Inappropriate soap use may result
in ineffective dispenser operation or clogging.
Soap containing any type of scrubbers will
cause the dispenser to leak or eventually fail.
Figure 5 Figure 6
πCHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com