unGer RINSE 'N' GO PLUS User manual

1
WATER
IN
2
Connect garden hose and connectors to outlet connection at top of unit
Connect the Soap Blasting Nozzle and start ow of water through the system,
you are now ready to wash your vehicle!
3 4
Connect the included connectors and hose to water source
Connect water source hose to inlet connection at the bottom of unit
™
QUICK-START
GUIDE
Thank you for your Unger purchase!
Let’s get started!
READ THIS FIRST
Contents under pressure.
Can cause severe injury or death from tank rupture.
This Quick-Start User Guide is not a substitute for reading
the User Manual. To reduce the risk of injury or death, user
must read and understand the User Manual before using
this product. This product is not intended for commercial
use. It is intended for residential application only.
1
2
3
4
WATER
OUT
WATER
IN
WATER
OUT
DO NOT REMOVE RESIN FROM NYLON BAG

ungerpro.com
For help with assembly or product information please call us, we are here to help.
1 [phone] Monday – Friday 8:30 AM – 5:00 PM EST (excluding major holidays)
or you can email: [e-mail]
DO NOT RETURN TO STORE, CALL US FIRST.
Our Rinse ‘N’ Go Plus Customer Support will assist you.
Your satisfaction is important
• Until water is owing out of system, keep water outlet open or press yellow pressure
release button down to remove trapped air from system.
• Do not exceed water pressure of 90 psi.
• Do not connect to pressure washer or auxiliary pump.
• Inspect system and any attachments for leaks, cracks, or dents.
• Be sure cover is in fully locked position.
• For use only with tap water.
IMPORTANT WARNINGS (SEE USER MANUAL FOR FULL LIST OF WARNINGS)
• Wash your car as you normally would to remove dirt and grime. The Soap Blasting
Car Wash Nozzle is a fast way to soap up your car.
• Using the Rinse ‘n’ Go Plus system, rinse car with pure (deionized) water. Make sure
to rinse every part of the car, including areas where soap might get stuck such as
trunk, fuel door, and lights.
• For best results, rinse the car twice to remove all soap. You are done! No need to
dry your car.
HOW TO WASH YOUR CAR USING RINSE ‘N’ GO PLUS
Unger recommends washing your car in the shade. Washing your car
under the hot sun will cause the soap to dry fast and potentially settle
on the car. If this can’t be avoided, be sure to keep the soap areas wet
until ready to rinse it off.
The pure water from the Rinse ‘N’ Go Plus system does all the work for you so that
your car will dry completely spot-free! Just like if you had it cleaned at a professional
car wash.