Westomatic EVOLVE User manual

ADJUSTING WATER/FLAVOUR
DISPENSE VOLUME

BOTTLE FILL CALCULATION:
F A C T O R Y D E F A U L T S E T T I N G = 5 0 0 M L I N 2 3 . 5 S
F L O W R A T E = 2 1 . 3 3 M L / S
BOTTLE SIZE
FLOW RATE =TIME IN SECONDS
330ML
21.33ML/S =15.47S
EG:
For example for a 330ml drink - 15.47seconds is entered into the water throw time.
IMPORTANT:
Water throw time should always be greater than protein throw time to ensure a well blended
drink and to ensure bowls are clean and clear after powder dispense.
S E T T I N G F L O W R A T E

ADJUSTING WATER DISPENSE VOLUME
Equipment Needed:
Measuring Jug (Min 1 litre)

U S I N G T H E B U T T O N S
Button 1 = UP
Button 2 = DOWN
Button 3 = CANCEL
Button 4 = ENTER
Button 1 = 1
Button 2 = 2
Button 3 = 3
Button 4 = 4
When needed to enter a passcode (Service Mode):

1 - A D J U S T S E T T I N G S U S I N G L C D
Open Door
In DOOR OPEN mode
Scroll down to SERVICE MODE
Using Button 4 -ENTER
Using the buttons
Enter code 3211

Scroll down to DRINKS
Using button 4 - ENTER
Scroll down to PROTEINS
Using button 4 - ENTER

Scroll down Protein Flavour
Using button 4 - ENTER
Scroll down to DRINK SETUP
Using button 4 - ENTER

Scroll down to MAIN WATER
Using button 4 - ENTER
Scroll down to BOTTLE FILL
Adjust the time to reflect
14.5secs is approx 300ml
Using button 4 - ENTER
Using button 3 - EXIT OUT & SAVE

If the water pressure needs adjusting
The Pressure Regulator is located at
the back of the machine
Pull cap on regulator out then turn
2 - A D J U S T I N G W A T E R F I L L P R E S S U R E
Clockwise = INCREASES Volume
Anti - Clockwise = DECREASES Volume

ADJUSTING FLAVOUR DISPENSE VOLUME
Equipment Needed:
Measuring Jug (Min 1 litre)
Gram Scale

S E T T I N G G R A M T H R O W S
Protein recipe is water throw and flavour shot.
Water throw is calculated using the equation previous.
Flavour shot - each dry mix powder has a different flow rate so cannot be predetermined.
Begin with a 5.0 second test throw time for the flavour.
Collect the throw (remove canister chute from canister)
Weigh content of the dry powder.
If Product recommendations suggest a gram throw of 30g, using the weight from the 5 second test
throw, calculate the grams per second - and then work out how many seconds are required.
So if 40g were thrown in 5 seconds = throw rate of 8g/s.
Using the formula below the throw time in seconds can be calculated:
Test the gram throw with the calculated time, and re-weigh the flavour shot.
PROTEIN SET UP:
FOR EXAMPLE:
WEIGHT OF POWDER (G)
TEST TIME (S) =GRAMS PER SEC
40G
5S =8G/S
EG:
REQUIRED WEIGHT OF POWDER (G)
GRAMS PER SECOND =THROW TIME (S)
30G
8G/S =3.75 SECONDS
EG:

U S I N G T H E B U T T O N S
Button 1 = UP
Button 2 = DOWN
Button 3 = CANCEL
Button 4 = ENTER
Button 1 = 1
Button 2 = 2
Button 3 = 3
Button 4 = 4
When needed to enter a passcode (Service Mode):

1 - A D J U S T S E T T I N G S U S I N G L C D
Open Door
In DOOR OPEN mode
Scroll down to SERVICE MODE
Using Button 4 -ENTER
Using the buttons
Enter code 3211

Scroll down to DRINKS
Using button 4 - ENTER
Scroll down to PROTEINS
Using button 4 - ENTER

Scroll down Protein Flavour
Using button 4 - ENTER
Scroll down to DRINK THROWS
Using button 4 - ENTER

Scroll down to FLAVOUR SHOT
Using button 4 - ENTER
Scroll down to BOTTLE FILL
Adjust the time to reflect
14.5secs is approx 300ml
Using button 4 - ENTER
Using button 3 - EXIT OUT & SAVE

W e s t o m a t i c V e n d i n g
S e r v i c e s L t d ,
U n i t s 7 - 8 F o r d e C o u r t ,
B l o c k 4 F o r d e R o a d ,
N e w t o n A b b o t ,
T Q 1 2 4 B T
+ 4 4 ( 0 ) 1 6 2 6 3 2 3 1 0 0
s a l e s @ w e s t o m a t i c . c o m
w w w . w e s t o m a t i c . c o m
CONTACT
RECOVER. REPEAT.