Yale Nest x Yale Installation guide

P/N -540-INST-FUL Rev 4AYRD
1
Nest x Yale Lock
Installation and Programming Guide
Before you begin
for step-by-step installation
instructions & to register
your product
DOWNLOAD
THE BILT APP
Keypad
Check
(Set / Continue)
Settings
Speaker
Failsafe 9 volt
Battery Connection
(Use Alkaline battery)
Warning Status
Indicator
Back button
Low Battery
Indicator
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN DAMAGE TO THE PRODUCT AND VOID THE FACTORY WARRANTY
Battery Cover
Key
AA Alkaline
Batteries
Deadbolt
Strike Plate
Inside
Mounting Plate
Inside Lock
Battery Cover
000XXX
XXXX0000000

P/N -540-INST-FUL Rev 4AYRD
2
1"
[25mm]
Dia.
C
L
FOLD OVER DOOR EDGE
C
L
C
L
C
L
C
L
1"
[25mm]
Dia.
2-1/8"
[54mm]
Thru Hole
Dia
2-1/8"
[54mm]
Thru Hole
Dia
CAUTION:
If printed from electronic
Measure ruler to check scale
file set print s 1:1cale to
2" 1" 0"
50mm 25mm
0"
25mm 50mm 75mm
2" 3"
1"
CUT LINE
For 1-3/8"
[35mm]
Thick Door 2-3/8" [60mm] Backset
2-3/4" [70mm] Backset
For 1-3/4"
[44.5mm]
Thick Door
Template
Tools Needed
Utility Knife
Drill Wood Mortise
Chisel
Pencil
Tape
Measure
Level
Provided Fasteners
Standard
Phillips Head
Screwdriver
OR OR
Silver
for
2 to 2-1/4"
Door Thickness
Black
forStandard
1-3/4"
Door Thickness
Green
for
1-3/8"
Door Thickness
Strike Plate
and
Latch Screws
Inside Lock
Screws
Tools necessary only for new doors
or adjusting existing prep.
Optional
Security
Strike Plate
Screws

Before you begin, open door and remove your existing deadbolt.
Before you begin, double check your door prep measurements.
EXISTING
2-3/8" or 2-3/4"
(60mm or 70mm)
Backset
2-1/8" (54mm)
Diameter
EXISTING
See
Door Prep
Template
5-1/2" (140mm) Standard
Check clearance with
lower hardware if this
dimension is less than
5-1/2" (140mm).
1" (25mm)
Deep
!
Drill holes 1/2 way
through door then
complete from other side
to prevent splitting.
2-1/8"
(54mm)
Dia.
2-3/8" (60mm)
or
2-3/4" (70mm)
Backset
1"
(25mm)
Dia.
Frame
See
Door Prep
Template
Inside
of Door
Frame
Necessary only for new doors or adjusting existing prep.
Before you begin, prepare door & frame.
P/N -540-INST-FUL Rev 4AYRD
3

P/N -540-INST-FUL Rev 4AYRD
4
2-3/8" (60mm) Position
UP
2-3/4" (70mm)
Position
x2
Installing Deadbolt
1
OR
Press
Pull
UP
Bolt must be in retracted
(unlocked) position.
Mechanism will be horizontal.
Note UP arrow on deadbolt.
!
Mechanism
(Horizontal Orientation)
*Backset
2-3/8" (60mm)
Backset
2-3/4" (70mm)
Backset
*2-3/8" (60mm) or 2-3/4" (70mm)
Installing Strike Plate
2
Frame
x2
x2
Choose
standard
strike plate
screws or
security
screws.
!

P/N -540-INST-FUL Rev 4AYRD
5
Installing Keypad
Outside of DoorInside of Door
3
Bolt must be in retracted
(unlocked) position. Note
horizontal orientation of
mechanism.
!
Installing Interior Mounting Plate
Choose
through bolt
appropriate
for your door
thickness.
See Page 3.
x2
!
4
Inside of Door
Make sure
plate and
keypad are
level before
tightening
through
bolts.
!

P/N -540-INST-FUL Rev 4AYRD
6
Removing Battery Cover
5
000XXX
XXXX0000000
Attaching the Cable
6
Make sure to
connect cable
with black mark
side up.
!
Secure cable
in hooks.
!

P/N -540-INST-FUL Rev 4AYRD
7
Installing Inside Lock
7
x2
Make sure
bolt is
retracted.
!
000XXX
XXXX0000000
Make sure inside lock is properly seated
onto bottom of mounting plate and
excess cable is tucked into lock cavity.
!
Testing Operation
8
Close door and
check bolt
operation.
Bolt should rotate freely and easily.
Go back to step 3 to recheck
installation if there is resistance.
000XXX
XXXX0000000

P/N -540-INST-FUL Rev 4AYRD
8
Installing Cover
10
Congratulations, you've installed the Nest x Yale Lock!
000XXX
XXXX0000000
Programming Instructions
Touch Yale logo to wake lock.
You will be guided to set up the Master Passcode by following the audio
instructions on the lock. Once installation is complete, download the Nest App to
add the lock to your Nest account.
Additional passcodes and further programming can be done in the Nest app. Note
that the Master Passcode may also need to be set within the app. Once the Nest x
Yale Lock is paired with the Nest app, 20 passcodes will be available for use.
For written programming/troubleshooting instructions and instructions in other
languages, visit www.ShopYaleHome.com/NestYaleLock/Info
Failsafe 9 volt
Battery Connection
(Use Alkaline battery)
Product Support Tel: [phone] • www.yalehome.com
Yale Locks & Hardware is a division of Yale Security Inc., an ASSA ABLOY Group company.
ASSA ABLOY is the global leader in door opening solutions,
dedicated to satisfying end-user needs for security, safety and convenience.
Yale® is a registered trademark of Yale Security Inc., an ASSA ABLOY Group Company. Nest is a trademark of Nest Labs, Inc.
© Copyright 2018, Yale Security Inc., an ASSA ABLOY Group Company. All rights reserved.
Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.
Certified ANSI/BHMA A156.36 Grade 2 | Nest Labs Designed in the US nest.com Built in China | Patent & TM: nest.com/legal/ip-and-other-notices | Open source: nest.com/legal/compliance
Installing Batteries/Handing the Lock
9
“Hi from
Yale and Nest.”
Door must be closed
prior to inserting
batteries.
Lock automatically
calibrates itself for
use after battery
installation.
000XXX
XXXX0000000