Assa Abloy EMTEK User manual

Installation Guide - Non-Keyed plates: Knob
IMPORTANT!: Knob location on the sideplate (Top, middle, bottom) varies depending on style.
Determine proper orientation BEFORE drilling holes.
IN4-NKEYPLTSKNB REV. 19A 11-22-19
2. Door Prep1. Determine knob location & plate orientation
4. Mount Inside Trim Plate
Edge
Guide
Provided
Plates and knobs vary depending on style
6. Tighten Knob
Optional Thru Bolts
3. Install latch
BOTTOM MIDDLE TOP
21
4"
2-3/8"
or
2-3/4"
1" Dia.
Edge Bores
2-1/8" Dia.
Bores
5. Mount Outside Trim Plate
Dummy plate
For Privacy function:
Threaded hole for the
privacy pin must face
the interior side of the
door.
Prior to drilling holes, align side plate
using Edge Guide (provided).
OutsideInside
Privacy Function
Make sure the release
hole lines up with the
privacy pin.
Thru bolts (provided)
may be used on hollow
doors instead of wood
screws (also provided).
After lock has been installed tighten
set screw with Allen Wrench.
Align Mounting
plate (sideplate not
shown for clarity)
2
1
Install Mounting Plate & Adjust for level
2
3
1
3Install Sideplate

Installation Guide - Non-Keyed plates: Lever
IMPORTANT!: Lever location on the sideplate (Top, middle, bottom) varies depending on style.
Determine proper orientation BEFORE drilling holes.
IN4-NKEYPLTSLVR REV. 19A 11-22-19
2. Door Prep1. Determine lever location & plate orientation
4. Mount Inside Trim Plate
Edge
Guide
Provided
Plates and lever vary depending on style
6. Tighten Lever
Optional Thru BoltsPrivacy Function
3. Install latch
BOTTOM
OutsideInside
MIDDLE TOP
Prior to drilling holes, align side plate
using Edge Guide (provided).
For Privacy function:
Threaded hole for the
privacy pin must face
the interior side of the
door.
21
4"
2-3/8"
or
2-3/4"
1" Dia.
Edge Bores
2-1/8" Dia.
Bores
5. Mount Outside Trim Plate
Thru bolts (provided)
may be used on hollow
doors instead of wood
screws (also provided).
Make sure the release
hole lines up with the
privacy pin.
After lock has been installed tighten
set screw with Allen Wrench.
Align Mounting
plate (sideplate not
shown for clarity)
1
2
3
Install Mounting Plate & Adjust for level
Install Sideplate
Dummy plate
23
1