Ballard Designs Newport Demilune TC351 User manual

PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 4-3-2020 Page 1 of 4
PRODUCT NAME: Newport Demilune Table with Doors
ITEM NUMBER: TC351
ASSEMBLED DIMENSIONS : 32”H x 38”W x 14 1/4”D
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
MADE IN CHINA

Customer Service: 800-367-2810
Online: www.ballarddesigns.com Page 2 of 4
Ltr. Qty. Components
REQUIRED TOOLS:
Phillips Screwdriver,
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
NOTE: To avoid accidentally
discarding small parts or hardware,
retain all carton contents until
assembly and installation are complete.
D
E1
1
Shelf (E)
Table (D)
WARNING
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
ANCHORING HARDWARE INCLUDED
Ltr.
A 4
B 4
Qty. Hardware Included
C 2
Dowels
Wall Anchoring
(Anti-tip) Kits
See page 4
Assemble in location for intended use.
Shelf Supports

Page 3 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
STEP 1: Insert Shelf Supports (A) into pre-drilled holes located inside Table then place Shelf (E) level
upon Supports.
(A) (E)
STEP 2: Slightly pull out Drawers and insert Dowel (B) drawer stops into pre-drilled holes as illustrated.
(B)

Page 4 of 4
Installation:
Cleaning & Care:
DO NOT use alcohol based products or spray polisher as
they can damage the finish. Dust with soft cloth.
(B)
(A)
(C)
(C)
(D)
Ltr.
A2
Small Screw
Retention Belt
Qty. Hardware Included
B2
Large Screw
C4 Bracket
D2
ANCHORING HARDWARE (ANTI-TIP)
1. Locate and mark a Wall Stud behind unit at location for installation.
2. Corresponding to Stud location, attach one Bracket (C) to back of unit using Small Screw (B).
3. To keep hardware out of view after installation, attach remaining Bracket (C) INTO WALL STUD
with Large Screw (A) 2 inches below Bracket attached to back of unit.
4. Move unit into place, align Brackets then connect both using Retention Belt (D).
5. Confirm Belt is securely laced and locked.
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
WALL BRACKET MUST BE ATTACHED TO WALL STUD
WALL
STUD
BACK OF FURNITURE ITEM
Customer Service: 800-367-2810
Online: www.ballarddesigns.com