Ballard Designs Bunny Williams La Colina JC226 User manual

PRODUCT NAME: La Colina Coffee Table
ITEM NUMBER: JC226
DIMENSIONS OF ITEM ASSEMBLED: 18 1/4”H x 48”W x 48”D
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATE: 11/18/2016 Page 1 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
MADE IN CHINA

Customer Service: 800-367-2810
Online: www.ballarddesigns.com Page 2 of 4
TOOLS NEEDED:
-Assembly requires 2 people.
-May require a Wrench.
NOTE: When unpacking, lay the
parts on a padded surface such
as the packaging provided.
Be sure to locate all hardware
before throwing away
any packaging.
Ltr.
A
B
8 Hex Bolts
8 Large Lock Washers
Qty. Hardware Included
Ltr.
I 1
Qty. Components
C 8 Large Washers
D 4 Allen Bolts
E 4 Small Lock Washers
F 4 Small Washers
G 4 Plastic Caps
H 1 Allen Wrench
J 1
K 1
L 4
Table Top (I)
Top Frame (J)
Bottom Frame (K)
Legs (L)

Page 3 of 4
Turn the Top Frame (J) upside down on a smooth, clean surface such as the packaging
provided. Loosely attach the Table Legs (L) to the Top Frame with the Hex Bolts (A),
Large Lock Washers (B), and Large Washers (C).
STEP 2:
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
STEP 1:
WARNING: Aluminum is a soft metal and over-tightening will strip the thread or break the part.
(A)
(B)
(C)
Loosely attach the Bottom Frame (K) to the Legs (L) by screwing in the Allen Bolts (D),
Small Lock Washers (E), and Small Washers (F) from the inside of the center plate
with the Allen Wrench (H). Then place the Plastic Caps (G) on the Allen Bolts.
After the Bottom Frame is attached, fully tighten all bolts on the Table Top (J).
(J)
(L)
(K)
(L)
(J)
(D)
(E)
(F)
(G)

Page 4 of 4
IMPORTANT:
Aluminum is a soft metal and overtightening will strip the
thread or break the part.
STEP 3:
Cleaning & Care:
DO NOT use acid or alkaline washing liquid to clean this product.
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
(I)
(J)
Carefully lay the Table Top (I) into the Top Frame (J).
(L)
STEP 4: If the assembled unit is uneven, adjust the levelers located underneath the Legs (L).
Carefully elevate one side of the table and turn the levelers clockwise or
counterclockwise until the unit is even.