Ballard Designs CASA Florentina User manual

PRODUCT NAME: Medici Secretary Desk with Hutch
ITEM NUMBER: MO323
ASSEMBLED DIMENSIONS: 72 1/4”H x 25”W x 14 1/2”D
PRODUCT NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 3-16-2020
MADE IN ITALY
Page 1 of 4
Customer Service : 800-367-2810
Online: www.ballarddesigns.com

Page 2 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Assemble in location for intended use.
Ltr.
A 8
B 2
Qty. Hardware Included
Ltr.
D
E
Qty. Components
C 8
REQUIRED TOOLS:
Phillips Screwdriver
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
NOTE: To avoid accidentally
discarding small parts or hardware,
retain all carton contents until
assembly and installation are complete.
F
G
H
1
1
Hutch (F)
Desk (G)
Shelves (H)
1
Screws
Connector Plates
Shelf Supports
Key
Wall Anchoring
(Anti-tip) Kit
See page 5
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
ANCHORING HARDWARE INCLUDED
2
1

Customer Service: 800-367-2810
Online: www.ballarddesigns.com Page 3 of 4
Cleaning & Care
Do not use alcohol based products or spray polisher as finish damage may result.
Periodically dust with a soft, dry cloth.
STEP 1: Carefully lift Hutch (F) and place on top of Desk (G). Center and align then join both together
by placing Connector Brackets (B) as illustrated below and securing with Screws (A).
WARNING: To prevent tip-over, Connector Brackets (B) must be used to join units.
STEP 2: Determine location for each Shelf (H) then insert Shelf Supports (C) into corresponding
pre-drilled holes. Carefully set each Shelf level upon Supports.
(A)
(B)
NOTE: Attach the
Brackets near the edges
for the best support.
(C)
(H)

Customer Service: 800-367-2810
Online: www.ballarddesigns.com Page 4 of 4
Installation:
Ltr.
A1
Small Screw
Retention Belt
Qty. Hardware Included
B1
Large Screw
C2 Bracket
D1
WALL ANCHORING HARDWARE (ANTI-TIP)
1. Place furniture against wall at desired location then locate and mark a Wall Stud behind unit.
2. Corresponding to Stud location, attach one Bracket (C) to back of unit using Small Screw (B).
3. To keep hardware out of view after installation, attach remaining Bracket (C) INTO WALL STUD
with Large Screw (A) 2 inches below Bracket attached to back of unit.
4. Move unit into place, align Brackets then connect both using Retention Belt (D).
5. Confirm Belt is securely laced and locked.
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
W
A
L
L
S
TUD
WALL BRACKET MUST BE ATTACHED TO WALL STUD
(A)
(B)
(C)
(D)
R
e
presen
t
a
tiv
e
Fu
r
nitu
r
e
I
tem