Ballard Designs WS973 User manual

PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 7/26/2019 Page 1 of 5
PRODUCT NAME: Apothicaire Cabinet
ITEM NUMBER: WS973
ASSEMBLED DIMENSIONS : 30 7/8”H x 21”W x 6 1/2”D
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
MADE IN CHINA

Customer Service: 800-367-2810
Online: www.ballarddesigns.com Page 2 of 5
Ltr.
A 4
B 12
Qty. Hardware Included
Ltr.
D
F
1
3
Qty. Components
C 1
TOOLS NEEDED:
Phillips Screwdriver, Drill, Level, Pencil
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
NOTE: To avoid accidentally
discarding small parts or hardware,
retain all carton contents until
assembly and installation are complete.
E1
Hardware Packet
Shelves
Screws
Shelf Supports
Expansion Bolt
Wall Bracket
Shelves
Cabinet

Page 3 of 5
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
STEP 1: Determine location for cabinet then use a Level and Pencil to position and mark location
for Wall Bracket (D). Use Screws (A) in Wall Stud and Expansion Bolt (C) in open drywall.
NOTE: See Steps 2 and 3 for Expansion Bolt installation.
For maximum support, at least three holes
should be centered on a WALL STUD.
SAFETY NOTICE
(A)
(C)
(D)
STEP 2: EXPANSION BOLT For holes located in open drywall (no Wall Stud) pencil mark location
and use a drill and 1/4” bit to make a small pilot hole. Gently tap Expansion Bolt (C) into hole until
teeth sink into wall surface.
(C)
Teeth
FIRST THEN
WALL
STUD

Page 4 of 5
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
STEP 3: Using a Screwdriver, apply firm pressure while turning Bolt CLOCKWISE until Bolt begins to
slip indicating the barrel has crimped against inside of drywall. Completely back out and remove Bolt
from Wall. Place bracket on wall, align hole and replace Bolt. Firmly tighten to secure bracket.
FIRST THEN
STEP 4: Once Bracket (D) is secured to wall, align and engage Bracket on back of Cabinet (E)
with Bracket on wall. First, lift Cabinet Bracket over Wall bracket then gently slide Cabinet down to
lock both into place.
Wall Side
Wall Side
(D)
(D)
(E)
(E)

Page 5 of 5
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Cleaning & Care:
DO NOT use alcohol based products or spray polisher as finish damage may result.
Dust with a soft cloth.
STEP 5: Determine placement for each Shelf (F) then insert Shef Supports (B) in corresponding
pre-drilled holes. Gently place Shelf upon Supports.
(F)
(B)