BROSA Mia Wide Sideboard User manual

v1.0
ASSEMBLY GUIDE
Mia Wide Sideboard

Components
Upon unpacking your sideboard from it’s delivery box, you should have the
pieces shown below. Follow the steps on the next pages to assemble
your new sideboard.
Leg frame Right shelf
x 2 x 1
2 4
Drawer box unit Left shelf
x 1 x 1
1 3
Item Qty.Description Item Qty.Description
A
C
B
aa
bb
cc
Wood shelf support
Allen key
Hex head bolt
M6x15 Nylon strap
Flat head screw
04 x 17mm
Mounting plate
x 8
x 12
x 1
x 2
x 1
x 2

Step 1 1.1 Lay drawer box unit (1) on a at, stable, clean, and soft
surface. Position both leg frames (2) onto the pre-drilled holes
on drawer box unit (1) as shown. Ensure the pre-drilled holes
on leg frames (2) are aligned correctly with the pre-drilled
holes on drawer box unit (1) before attaching.
1.2 Secure both leg frame (2) to box unit (1) using hex head
bolts (B) as shown. Use allen key (C) to turn bolts (B) clockwise
to tighten until they are securely fastened.
B x 4
B x 4

Step 2 2.1 With help of assitant, carefully stand the unit upright.
2.2 Insert wood shelf support (A) into the pre-drilled holes
inside the unit as shown.
2.3 Tilt left & right wood shelves (3), (4) to a suitable angle as
shown in the picture so as to slide them in.
2.4 Insert shelves (3), (4) into the unit. Ensure the holes on
both shelves are facing down, then place them onto the pins of
wood shelf supports (A) as shown.
A x 8

Tip Kit Instructions
Notice: To prevent injury and property damage from unexpected tipping of furniture, we
highly recommend installation of the anti-tip kit included with this project.
Attaching furniture to wall with anti-tip kits.
1.
2.
3.
4.
5.
Determine where the piece is to be placed and mark location on the wall for the
mounting bracket screw holes. ey should be place approximately 1” below the
bottom of the back of the piece of furniture.
Drill the hole and use the appropriate wall plug that is suitable for your walls
composition. Warning: before drilling check wall for hidden pipes and cables.
Attach the mounting bracket vertically to the wall using appropriate fastener,
through the holes in the bracket and 2 wall plugs that are suitable to your wall and
then tighten securely.
Next using the short screws attach the 2nd bracket to the back of the piece of
furniture’s top.
Lace the nylon strap through the brackets. Slide the thin end of the strap through the
receiving end of the nylon strap. Pull to tighten the piece of furniture snug against
wall.
Wood Brick or Masonry Cavity Wall
If fixing to
wood make
sure that is isn’t
chipboard as
screws can
easily pull
away from the
core structure.
Use an
appropriate
wall plug
provided when
you are sure
your wall is
sound.
Special toggle
wall plugs are
needed. Seek
expert advice.