BROSA Majime Wide Sideboard User manual

ASSEMBLY GUIDE
Majime Wide Sideboard
v1.0

Components
Upon unpacking your storage from it’s delivery box, you should have the
separate pieces shown below. Follow the steps on the next pages to assemble
your new storage.
A x 12
(Shelf Support)
aa x 2
(Mounting Plate)
bb x 1
(Nylon Strap)
cc x 2
(Screw)
Hardware
What you need
Shelf x 3
Body x 1
B x 6
(Optional Handle)
C x 6
(Bolt M4x40mm)
D x 6
(Bolt M4x30mm)

Step 1 Open the doors as shown.
Remove the handle from doors and drawers by using
a screwdriver to turn round head bolts counter-
clockwise as shown.

Step 2 Attach handles to the doors and drawers using
round head bolts (C) (D).
Use a screwdriver to turn ttings clockwise to x.

Step 3
A x 12
Insert a pair of shelf supports (A) into the holes on
the one side of the storage compartment. Tilt the
shelf so it ts into the opening. Insert the shelf and
rest on the supports.
While holding the other side higher, insert the
second pair of supports (A) into the facing holes.
Lower the shelf until it rests securely on all four
supports. Repeat for the other shelfs.
1
1
1
A
A

Step 4 hinges if needed.
4.1 Vertical adjustment via slots on mounting plate
by slackening and retightening the screws on the
mounting plate.
4.2 Lateral adjustment by screw adjustent.
4.3 Front-to-Back adjustment by slackening and
retightening the hinge-arm mounting screw.
Step 4.1 Step 4.2
Step 4.3

Step 5 Turn the twist inside of the drawer to adjust it’s ver-
tical position, so that there are exqual gaps above
and below the front wall.
+2.5
-2.5

UNLOCK
Step 6 To take the drawer out, open it, pull out the Lock
button inside of the drawer. Gently lift the front part
of of the drawer.

Step 7 To put the drawer back in, attach the connector in
the back of the drawer. Gently put down the front
part of of the drawer so that the front connectors
attach. Push back the Lock button inside of the
drawer.
LOCK

Step 8 To use the optional handles (B) attach them to the
fronts of the drawers by using 6 long round head
blots (C). Use the shorter bolts (D) for the doors.
C x 6
D x 6