BROSA Nancy Desk User manual

ASSEMBLY GUIDE
Nancy Desk
v1.0

Components
Hardware
What you need
Legs x 2Body x 1
A x 14 (Bolt)
(Spec: M6xL32)
B x 14 (Washer)
(Spec: 14x8)
C x 14
(Plastic Cap)
Before you get started, check you have all of the pieces below. If anything’s
missing, please visit www.brosa.com.au/pages/product-return-and-parts-request
and we’ll sort it out right away.

Step 1
A x 14
B x 14
Align a leg to the underside of the body so that the screw
holes are overlapping. Fit a washer (B) to a bolt (A) and screw
into a hole using a screwdriver. Repeat for the other holes
then for the second leg. Cover the bolt holes with the plastic
caps (C).
G x 14
C
A
B

Step 2 Align the drawer slides with the corresponding holes
on the side walls. Secure into place using at end
screws (D).
D x 6
Step 3 Use the pointed end screws (E) to secure the slides.
E x 4
D
E
E

Step 4 Align the end hole on the drawer with the hook on the
slide and insert the drawer halfway into the cabinet.
Step 5 Pull the side lock out.

Step 7 Push back the side lock to x the drawer to the slide
and close the drawer.
Step 6 Alight the vertical knob on the slide with the hole on
the drawer and lift the drawer down.

Step 8
Step 8.1
Step 8.2
Step 8.4
Step 8.3
Reverse those steps to remove the drawer from the
storage. Open the drawer, pull the side lock out and
take out the drawer.

Step 9
±2mm
Rotate the knob on the side of the drawer to adjust
the angle.

Step 10 Place the desk upright on a level surface. Enjoy your
new desk!