Dometic Rastrollo 2000 User manual

Dometic Seitz GmbH 1Rastrollo2000.doc
Altkrautheimer Straße 28 • Tel: [phone].2008
D-74238 Krautheim / Jagst
Rastrollo 2000
PROBLEM DESCRIPTION:
Defective spring motor
Exchanging blind or flynet
Rollo does not retract fully to the end position
Exchanging the end hooks
Spring motor
Blind
Flynet
End hook
Tensioning bush
Cassette
Side tracks
Cassette end caps

Dometic Seitz GmbH 2Rastrollo2000.doc
Altkrautheimer Straße 28 • Tel: [phone].2008
D-74238 Krautheim / Jagst
Defective spring motor
Remove the end caps from the cassette and unwind the spring motor
using a screwdriver. Turn the tensioning bush clockwise until it cannot be
turned further and pull outwards carefully.
Attention! Risk of injury resulting from the spring jumping out or
recoiling uncontrollably.
.
Press the spring shaft back in the cassette with your finger or pliers and
remove the rollos. Pull out the spring motor from the grooved tube and
insert the new spring motor, insert blind in the cassette, place the
tensioning bush and wind according to the winding rule below. Place the
tensioning bush in its housing and turn in an anti-clockwise direction
until it cannot be turned further.
Winding rule: Tube length in mm/100 +3= revolutions of the spring shaft
Example: Tube length =1000mm 1000mm/100+3= 13 i.e.13 revolutions in a
clockwise direction
Exchanging blind or flynet
Remove Rollo as per defective spring motor and exchange corresponding Rollo. Re-assemble
in reverse order.
Rollos do not retract fully to the end position
Check Rollo tension according to the winding rule and rewind.
If rollos still do not run properly check spring motor and change if necessary.
Exchanging the end hooks
By using a screwdriver for leverage remove the end hooks and exchange.
In order to attach the end hooks please use instant glue. Should the end
hooks get broken during removal and remain in the end bar, they are to
be removed by using a screwdriver.