emaux LED-P10 User manual

EMLI15031471
DANGER
WARNING
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION
This underwater light must be installed by a licensed or certified electrician in
accordance with the National Electrical Code and all applicable local
codes and ordinances. Improper installation will create an electrical hazard
which could result in death or serious injury to pool users, installer, or others
due to electrical shock, and may also cause damage to property. Read and
follow the specific instructions below.
UNDERWATER LIGHT OPERATING MANUAL
Keep this manual for future reference
LED-P10
1-2
IMPORTANT NOTICE
Attention Installer.
This manual contains important information about the installation, operation
and safe use of this product. This information should be given to the owner
/operator of this equipment.
Before installing this underwater light, read and follow all warning notices and
instructions accompanying this light. Failure to follow safety warnings and
instructions can result in severe injury, death, or property damage.
Voltage: AC 12V Frequency: 50/60Hz Power: 1W
Installation instructions
1)T his underwater lights mounted to the trial in the 2 "PVC pipe
Metric 1.25Mpa),before installation,selecting a suitable PVC pipe.(Note:
Due to a variety of different wall thickness PVC pipe, please refer to Figure 1
to choose appropriate size of tube)
2) To ensure pool electrical systems compliance with national act requires,
before installation. Electrical system must be made by the official figuren
licensed electrician or qualifies electrician to install.
3) Underwater lamp circuit requires leakage protection socket and breaker.
4) 2 "PVC pipe installation with complete swimming pool flat surface,
(Imperial 12Bar,

2-2
1) Underwater light cannot be turn on more then 1 minutes unless there is
water.
2) Underwater light installed inside the pool should be filled with pool water
and cannot be prolonged exposure to sunlight.
3) Before installed the underwater lights , check the water lamp is fully
immersed in water; electrical boxes and circuit are normal.
4) This product cannot be maintenance, if there is a problem, please replace
the product.
5) Before installation of water lights, disconnect all the main electrical power
and not to control by wet hands.
6) Remove and replace of water light, simply use a flathead screwdriver from
the side to eject. (Figure 6)
Underwater light care and maintenance.
55.10
52.10
∅64.00
7.00
Figure 1 Figure 2
400-700mm
2"PVC PIPE
Figure 3
Figure 4 Figure 5 Figure 6
underwater lights installed and the water surface distance between 40cm-
70cm. (Figure 2)
5) When installing underwater lights, be parpare long enough cable(Min 1m)
to ensure that maintenance and replacement lamp can be out of the
water. (Figure 3)
6) When installing underwater lights, Please refer to Figure 4 and Figure 5 of
the lamp into the PVC pipe.