fantastic furniture FORM User manual

FORM
Table D4 Round
Assembly Instructions
Ver1.0

Page 2
2
3
56
Read Instructions carefully.
Lay out all of the components on a soft surface
as if you were preparing to do a jigsaw puzzle.
Carefully identify each component, especially
those that are similar. The most common mistake
is getting things back to front.
Separate and identify each component from the
hardware pack and rest each one in its proper
WARNING
WARNING
Check no parts are missing.
4
fully tighten screws（leave slightly
loose.When the item is fully assembled
tighten the screws - but do not over tighten.
FAILURE TO FOLLOW THESE BASIC STEPS CAN LEAD TO DAMAGE
THAT IS NOT COVERED BY YOUR WARRANTY
If glue is required DO NOT set until you are
certain that the parts belong together.

Page 3
Please make sure you have all these parts before you start.
Allen Key provided
8 x Bolts
(H1)
4 x Short Screws
(H3)
What you Need
To Assemble the Body
( not provided)
Phillips Head Screwdriver
Leg
(P1) Leg
(P1)
Support Bar (P2)
Support Bar (P2)
Top
(P3)
4 x Long Screws
(H2)

You will need:
8 X Bolts
(H1)
Step 1
(P1)
(P1)
(P2)
(P2)
(H1)
(H1)
(H1)
(H1)
(H1)
Attach 2 x Support Bars (P2) and 2 x Legs (P1) with 8 x Bolts (H1),
Make sure the hole brackets face inside
Do not fully tighten.
You will need:
4 X Long Screws
(H2)
Step 2
(P3)
(H3)
(H2)
(H2)
Position Top (P3) upside down on
a soft flat surface to prevent surface damage
during assembly.
Attach metal frame to Top (P3)
with 4 x Long Screws (H2) + 4 Short Screws (H3) by
using Phillips Head Screwdriver, make sure that the holes on the
metal frame are aligned with the pre-drilled holes of the bottom of the Top (P3) first.
Fully tighten Screws.
(H3)
Page 4
ATTENTION: DO NOT MISPLACE H2 LONG SCREW IN H3 POSITION
FOR PROTECTION OF TABLE TOP
4 X Short Screws
(H3)
(H3)
(H2)

Page 5
Step 3
The job is now complete!
In the interest of our environment
Please dispose of all packaging thoughtfully.
Put the table on an even floor and tighten all Bolts (H1) with Allen Key provided.
Step 4