Häfele FITT-10111 User manual

Tools required (Not Supplied)
Component parts
150mm Pull-Out:
Assembly guide
Sales and Technical Support -
Tel: [phone], Fax: [phone], E-Mail: [email protected]
Sales and Technical Support -
Tel: [phone], Fax: [phone], E-Mail: [email protected]
• Make sure all the components are included before
you start.
• The number for technical support is at the bottom
of the page.
• Don't rush!
• Read the instructions first.
• Assemble in the stages shown.
• Keep the fittings together to avoid loss.
• Have fun.
SW4 Allen key
460
475
150 mm
cabinet
width
52
77
298
355
420
Front edge of carcase
2 x Baskets (A)
1 x Frame (B)
2 x Runners (C)
2 x
Door front fixing
bracket (D)
4 x 6.0 (M6)
Hexagon nut
(E)
15 x Screw
4.0 x 15 mm
(G) 6 x Bolts
6.0 x 10 mm
(H)
Using the runner drilling pattern shown below, fix
the runners (C) to the inside face of the cabinet,
using 4.0 x 15 mm pan head screws (G) to the internal
side of the carcase a minimum of 20 mm up from the
floor level of cabinet.
1
Pencil
Bradawl
Spirit Level Cross Head Screwdriver Tape measure
Did you know Häfele also supply tools to the trade and industry?
See www.hafele.co.uk for more information.
FITT-10111
OLD REF: 500.00-0107
Hafele Cat. No: 546.21.233
4 x M6
locking washer
(F)
36
425
Hole centre distance

Fix the door front to the fixing brackets (D), using 4.0 x 6.0 x 10 mm
screws (H), use the measuring guide above to assist (ENSURING
THAT THE SCREWS DO NOT PENETRATE THROUGH THE DOOR FRONT),
Place baskets (A) onto the hooks with the vertical wires on each basket
inside the hooks on the frame (B).
4
Attach the door front fixing Brackets (D) to frame (B) using
2 x 6.0 x10 mm bolts (H).
3
Sales and Technical Support -
Tel: [phone], Fax: [phone], E-Mail: [email protected]
Sales and Technical Support -
Tel: [phone], Fax: [phone], E-Mail: [email protected]
2
Attach the frame (B) to runners (C) with the 2 threaded bolts
on each of the runners going through the matching holes on
the horizontal edge of the frame. Secure with 4 x locking washers
(F) and 4 x hexagon nuts (E).
A = 70 mm + door overlay
B = 360 mm
C = 42 mm + door overlay
D = 40 mm
A
B
CD