Havis 1996-2008 Crown Victoria Driver and Passenger - Trunk Side Mounts... Configuration guide

Havis, Inc.
75 Jacksonville Road, PO Box 2099
Warminster, PA 18974
T 800-524-9900 F 215-957-0729
www.havis.com
1
C-TSM-CV-P_INST_6-09
INSTALL INSTRUCTIONS
C-TSM-CV-D and C-TSM-CV-P
1996-2008 CROWN VICTORIA
DRIVER and PASSENGER - TRUNK SIDE MOUNTS
• Drill with 1/8” and 3/16” drill bits
• Open End Wrench - 3/8”
• Phillips Screwdriver
TOOLS REQUIRED:
QTY: DESCRIPTION: PART #:
3 10/32 X 1/2” Machine Screw GSM33118
3 10/32 Keps Nut GSM30028
3 #10 x 3/4” Sheet Metal Screw GSM33195
HARDWARE:
Always!
• Read all instructions before installing any Havis, Inc. products.
• Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
• Use hardware provided with install kit
LINE DRAWING:
Passenger Side shown
# C-TSM-CV-P

Havis, Inc.
75 Jacksonville Road, PO Box 2099
Warminster, PA 18974
T 800-524-9900 F 215-957-0729
www.havis.com
C-TSM-CV-P_INST_6-09
2
Position frame assembly as shown.
Trunk liner does not have to be removed, but
you may want to cut it as needed to improve
access for routing wires.
Installation:
Top frame mount attachs to the trunk
gasket mounting ange.
Drill three holes with a 3/16” (.187”) drill bit.
Bottom frame mount attaches to the trunk
side oor. Drill three pilot holes with a 1/8”
(.125”) drill bit.
* Always check under oor before drilling *
Attach top frame with three (3) - 10/32” x
1/2” machine screws and keps nuts.
Attach bottom frame with three (3) - # 10 x
3/4” sheet metal screws.
Driver side Trunk Side Mount complete.
Install electrical components as desired.