Havis C-TMW-CV-01 Configuration guide

INSTALL INSTRUCTIONS C-TMW-CV-01
1995-2011 FORD CROWN VICTORIA TUNNEL MOUNT KIT
TOOLS REQUIRED:
Ratcheting Wrench
Metric Socket Set Standard Socket Set Tape Measure
Pencil
HARDWARE:
QTY DESCRIPTION PART#
20 ¼” x ¾” Hex head bolt GSM33001
8 ¼” Serrated nut GSM30023
12 ¼” Flat washer GSM31005
12 ¼” Split lock washer GSM31026
4 ¼” nut GSM30005
28” long x 8” wide
Tunnel Extrusion
Rear Hump
Brackets (C-B53)
Front Hump
Bracket (C-B33)
TUNNEL-MOUNT
ASSEMBLY
Plastic End Cap
Note:
Additional 1/4" hardware is provided for mounting C-HDM-200 series poles to the Trak.

C-TMW-CV-01_INST_4-15
2
HUMP BRACKET SUB ASSEMBLY:
Loosely assemble the three (3) piece front hump bracket # C-B33 and the three (3) piece rear
hump bracket # C-B53 with ¼” x ¾” hex bolts, Lock washers and flat washers.
Three piece brackets include a Driver side leg, Passenger side leg and a cross over plate.
INSTALLATION:
1. REMOVE SEATS:
•Remove rear seat base nuts (18mm).
•Slide seat to rear most position.
•Remove front seat base bolts (13mm).
•Seats do not have to come out of vehicle, but installation of hump brackets and tunnel
plate is much easier if they are removed. Unplug wiring underneath seats if removing
seats.
2. MOUNT ASSEMBLED HUMP BRACKETS and TUNNEL EXTRUSION:
•Loosely place the front and rear hump bracket legs onto the seat bolts.
•Place the 28” extrusion onto hump brackets and mark or measure desired location.
•Remove crossover brackets and attach to the bottom side of the extrusion with 1/4 x 3/4
hex head bolts and serrated nuts. (head of bolt goes into extrusion slots)
•Place the extrusion with crossover brackets on hump bracket legs.
•Bolt extrusion with crossover brackets onto hump bracket legs and tighten hardware.
•Re-mount seats and tighten all hardware. ( you may want to wait until other equipment is
installed)
•Mount equipment console and other accessories on extrusion with ¼ hardware.
•When all items are mounted, attach plastic caps on the ends of the extrusion with self
adhesive tape. (already on end caps)
C-TMW-CV-01 Final assembly shown