Havis C-MCB-CV Configuration guide

C-MCB-CV_INST_6-096-09
INSTALL INSTRUCTIONS C-MCB-CV
DUAL IN-DASH MICROPHONE CLIP BRACKET
1995-2009 FORD CROWN VICTORIA
TOOLS REQUIRED:
Ratcheting wrench
Sockets - 7/16”, #10, #8
Screwdriver set
T-20 torx bit
Always!
Read all instructions before installing any Havis, Inc. products.
Disconnect the vehicle battery. Removing seat bolts on some vehicles may give the vehicles
computer a false reading, causing a warning light on the instrument cluster. This requires the
vehicles’ computer to be reset with a vehicle diagnostics tool.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use only hardware provided with install kit.
Police Package Crown Vic Dash.
Carefully remove trim panel
Remove hex head trim screws
shown above

C-MCB-CV_INST_6-096-09
2
Slide bracket between trim around
radio and the trim panel
previously removed
Replace screws previously
removed
Re-attach trim panel
Install microphone clip brackets
using #8 x ½” machine screws
and hex nuts
Final assembly