HOMCOM A91-108 User manual

ASSEMBLY INSTRUCTION
A91-108
INade077V01_UK
Sit-up Bench Installation Instruction
READ AND SAVE THIS INSTRUCTION FOR FUTURE USE

Accessory List:
(1)Main body support (1pcs include back cushion)
(2) Handrail (1pcs)
( 3 )P u s h - up s ( o n e l e ft a nd r i g h t )( 2p c s )
(4) Spring booster (1pcs) (5) Twisted disk (1pcs)
(A) Plastic handle nutM8 (1pcs) (B) Blot (2pcs)
(C) A n t i - l oo s e nu t M 8 ( 3p c s )
(D)Semicircular head socket cap screws
M8*35 (2pcs)
(E)Semicircular head socket cap screws M8*55
(1pcs)

Step 1. Install Handrail and hook rail
First expand (1) the main body support, then the holes correspond, and finally fix the
holes through the (B)bolt.
Step 2. Install Handrail
According to the preferences to choose a hole, the (2) the handrails of the rods into the
corresponding hole and fastened (A) M8 plastic handle nuts.
When this laser is in a fixed
state, the hook is in a rigid
state, and the hook is in flexible
rotation. (Specific References
for training)

Step 3. Install Push-ups
The first (3) is pinched into the fixed tube (note that the hole and the hole), and then
passed through the (D) M8 * 35 in Semicircular head socket cap screws, and finally (C)
M8 Anti-loose nut fastened.
Step 4. Install Twisted disk
First put the (5)twisted disk into the card slot (note that the hole and the hole alignment),
and then with(E) M8 * 50 of the semicircular head socket cap screws , and finally with
the (C) anti- loose nut fastening

Step 5. Install Spring booster
Press the (4) spring booster snap to place the snap opening (1) body support tab
(Note: the snap opening must be closed after insertion).
Step installation is complete: as shown

Disassembly diagram：