Hyco Sahara TH01B User manual

Product Instruction Manual
Sahara
TH01B, TH02B, TH03B, TH04B
Tubular Heater
Versio 3.2 Ja 2015
V16.9/3

Thank you for purchasing from the Hyco range of tubular heaters. Tubular
heaters provide a gentle, background heat and frost protection for a wide
range of applications such as conservatories, workshops, airing cupboards
and caravans. Please read and understand these instructions before
commencing installation, and leave them with the user upon completion
of installation.
1. Im ortant safety oints
The appliance carries a ‘Do not cover’ message; this applies whether partially
or fully covering the appliance.
The appliance can be connected to the fixed wiring of a property providing
is in accordance with the latest edition of the IEE wiring regulations and the
information supplied on the rating label.
Care and attention should all be taken if connecting the appliance to a timer
or any other such automatic switching device as a fire risk exists if the appliance
is covered or obstructed.
The appliance is only intended for horizontal installation, fire risk exists if
installed in any other orientation.
Do not install this appliance in the immediate surroundings of a shower,
bath or swimming pool.
Do not use the appliance if the power cord shows any sign of damage.
The surface of this appliance can become hot; never leave very young
children or very vulnerable people unsupervised with the heater.
Do not locate the appliance immediately below any electrical outlet.
Children of less than 3 years should be kept away unless continuously supervised.
3

Children aged from 3 years and less than 8 years shall only switch on/off the
appliance provided that it is has been placed or installed in its intended normal
operating position and they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved. Children aged from 3 years and less than 8 years shall not plug in,
regulate or clean the appliance or perform user maintenance.
2. Installation
Wall Mounting
E sure mi imum cleara ces are observed whe i stalli g the applia ce.
• Select a suitable positio for locati g the heater, e suri g all mi imum dista ces
are met as per figure A. I additio , all safety co sideratio s from sectio 2 of this
ma ual should be followed.
• Offer the heater to the i te ded mou ti g positio mark the four fixi g holes,
e suri g you mai tai a horizo tal level. (a spirit level is recomme ded).
• Drill the four holes a d i sert wall plugs.
• Faste the heater by locati g four screws a d e suri g they are drive tightly
i to the wall plugs.
Figure A (Mou ti g restrictio s)
Note: Guards are available and would be strongly recommended where there is a risk
of incidental contact with heater.
4
60mm Min.
Floor Mounting
60mm Min.
Floor Mounting
300mm Min.

Electrical
Electrical connection of the heater can be made by means of the pre-wired 5 amp
plug directly to any socket or alternatively via a fused spur connected to the fixed
wiring of the property. Ensure all safety warnings from section 2 of this manual are
followed.
• If the heater is to be connected to the fixed wiring of the property then
installation must include a double pole isolating switch with a break contact
distance of at least 3mm.
• Make the connections as:
Green/Yellow earth wire to terminal or marked “E”
Brown live wire to the terminal marked “L”
Blue neutral wire to the terminal marked “N”
3. O eration
Thermal cut-out
The tubular heater range is designed as a low powered gentle background heat
provider. It is designed to operate continuously until the environment reaches approx.
15 C at which point it may start to cycle in the safety cut-out feature.
This feature is only designed to prevent the external surface of the heater reaching
dangerous temperatures to touch; it will not react directly to the temperature of its
environment.
5
0

4. Maintenance
• Before cleaning the heater, ensure the power supply is disconnected and the heater as
cooled sufficiently.
• Wipe the exterior with a soft dry cloth.
• Do not use any chemical or abrasive cleaners.
6

5. S ecifications
Model TH01b TH02B TH03B TH04BT
Supply Supply 230V - 50HZ
I IP rating IP55
SSizei 1ft 2ft 3ft 4ft
PPower 45W 80W 135W 180W
Dimensions 55 x 305 x 55 55 x 610 x 55 55 x 915 x 55 55 x 1222 x 55
H x W x D (mm) mm mm mm mm
D
W
H

6. Guarantee and service olicy
This product is guaranteed against faulty materials and manufacture for a period of
one year from the date of purchase. Hyco will in its sole discretion replace, repair or
refund any faulty unit. Consequential costs such as labour charges or damage to
fittings and surroundings are expressly excluded.

hyco.co.uk
Hyco Manufacturing Ltd
Normandy Court
Express Way
Castleford, WF10 5NR
T 01924 225 200
F 01924 225 210
E [email protected]
INF RMATI N F R C RRECT DISP SAL F THE PR DUCT IN ACC RDANCE WITH THE
EUR PEAN DIRECTIVE 2002/96/E.
At the end of its working life this equipment must not be disposed of as household
waste. It must be taken to a local authority waste collection centre or to a dealer
providing this service. Disposing of electrical and electronic equipment separately
enables its components to be recovered and recycled to obtain significant savings in
energy and resources. In order to underline the duty to dispose of this equipment
separately, the product is marked with a crossed out dustbin.