Insportline ET500i User manual

1
USER MANUAL –EN
IN 8726 Elliptical Trainer inSPORTline ET500i

2
CONTENTS
SAFETY INSTRUCTIONS....................................................................................................................... 3
IMPORTANT NOTES.............................................................................................................................. 3
EXPLODED DRAWING........................................................................................................................... 5
PARTS LIST............................................................................................................................................ 6
CHECKLIST (CONTENTS OF PACKAGE)............................................................................................. 9
ASSEMBLY ........................................................................................................................................... 10
CONTROL PANEL ................................................................................................................................ 14
TERMS AND CONDITIONS OF WARRANTY, WARRANTY CLAIMS................................................. 18

3
SAFETY INSTRUCTIONS
•To ensure the best safety of the exerciser, regularly check it on damages and worn parts.
•If you pass on this exerciser to another person or if you allow another person to use it, make
sure that that person is familiar with the content and instructions in these instructions.
•Only one person should use the exerciser at a time.
•Before the first use and regularly make sure that all screws, bolts and other joints are properly
tightened and firmly seated.
•Before you start your work-out, remove all sharp-edged objects around the exerciser.
•Only use the exercise for your work-out if it works flawlessly.
•Any broken, worn or defective part must immediately be replaced and/or the exerciser must no
longer be used until it has been properly maintained and repaired.
•Parents and other supervisory persons should be aware of their responsibility, due to
situations which may arise for which the exerciser has not been designed and which may
occur due to children’s natural play instinct and interest in experimenting.
•If you do allow children to use this exerciser, be sure to take into consideration and assess
their mental and physical condition and development, and above all their temperament.
Children should use the exerciser only under adult supervision and be instructed on the
correct and proper use of the exerciser. The exerciser is not a toy.
•Make sure there is sufficient free space around the exerciser when you set it up.
•To avoid possible accidents, do not allow children to approach the exerciser without
supervision, since they may use it in a way for which it is not intended due to their natural play
instinct and interest in experimenting.
•Please note that an improper and excessive work-out may be harmful to your health.
•Please note that levers and other adjustment mechanisms are not projecting into the area of
movement during the work-out.
•When setting up the exerciser, please make sure that the exerciser is standing in a stable way
and that any possible unevenness of the floor is evened out.
•Always wear appropriate clothing and shoes which are suitable for your work-out on the
exerciser. The clothes must be designed in a way so that they will not get caught in any part of
the exerciser during the work-out due to their form (for example, length). Be sure to wear
appropriate shoes which are suitable for the work-out, firmly support the feet and which are
provided with a non-slip sole.
•Be sure to consult a physician before you start any exercise program. He may give you proper
hints and advice with respect to the individual intensity of stress for you as well as to your
work-out and sensible eating habits.
IMPORTANT NOTES
•Assemble the exerciser as per assembly instructions and be sure to only use the structural
parts provided with the exerciser and designed for it. Prior to the assembly, make sure the
contents of the delivery is complete by referring to the parts list of the assembly and operating
instructions.
•Be sure to set up the exerciser in a dry and even place and always protect it from humidity. If
you wish to protect the place particularly against pressure points, contamination, etc., it is
recommended to put a suitable, non-slip mat under the exerciser.

4
•The general rule is that exercisers and training devices are no toys. Therefore, they must only
be used by properly informed or instructed persons.
•Stop your work-out immediately in case of dizziness, nausea, chest pain or any other physical
symptoms. In case of doubt, consult your physician immediately.
•Children, disabled and handicapped persons should use the exercise only under supervision
and in presence of another person who may give support and useful instructions.
•Be sure that your body parts and those of other persons are never close to any moving parts
of the exerciser during its use.
•When adjusting the adjustable parts, make sure they are adjusted properly and note the
marked, maximum adjusting position, for example of the saddle support, respectively.
•Do not work out immediately after meals!

5
EXPLODED DRAWING

6
PARTS LIST
Part No.
Description
Qty
1
Main frame
1
2
Front stabilizer
1
3
Allen bolt M8x1.25x20L
18
4
Adjustable cap
2
5L
Left moveable cap
1
5R
Right moveable cap
1
6
Curved washer D22xD8.5x1.5T
16
7
Spring washer D15.4*D8.2*2.0T
22
8
Screw ST4x10L
6
10
Handlebar post
1
11
Pedal supporting tube
2
12L
Left moveable handlebar
1
12R
Right moveable handlebar
1
13
Front foot cap (inner)
2
14
Front foot cap (outer)
2
15
Half ball cap
2
16
Allen bolt M8*1.25*45
2
17
Protective cover (left)
2
18
Screw ST4x1.41x15L
2
19
Rear stabilizer
1
20
Square neck bolt M6*1*45L
4
21L
Left pedal
1
21R
Right pedal
1
22
Screw ST4.2x1.4x20L
19
23
Round cap
2
24
Round cap
2
25
Screw ST4.2x1.4x20L
4
26
C-clip D22.5*D18.5*1.2T
2
27
Electric cable
1
28
Sensor cable
1
29
Upper computer cable
1
30
Motor
1
31
Lower computer cable
1
32
Tension cable
1
33
Crank
2

7
34
Belt wheel
1
35
Belt
1
36L
Left chain cover
1
36R
Right chain cover
1
37
Flywheel
1
38
Protective cover (right)
2
39
Side cover
2
40
Bolt M8*1.25*20L
4
41
Fixing ring
2
42
Round cover
2
43
Bearing #6004-2RS (C0)
2
44
Screw ST3.5*1.27*15L
8
45
Waved washer D21*D16.2*0.3T
1
46
Metal flat washer D30*D10*4.0T
1
47
Flat washer D50*D10*3T
1
48
Spacer (small) D10*D14*3T
1
49
Inner tube
2
50
Anti-loosen nut 3/8"-26UNFx6.5T
2
51
Plastic washer D50*D10*1.0T
1
52
Supporting tube for moveable bar
2
53
Foam
2
54
Foam
2
55
Mushroom cap
2
56
Spring D4.0xD20x82L
1
57
Nylon nut M6x1.0x6T
4
58
Bolt M6x1.0x15L
4
59
Bearing #2203-2RS
2
60
Flat washer D26*D21*1.5T
1
61
Crank axle
1
62
Round magnet
1
63
Waved washer D27*D20.3*0.5T
1
64
Computer
1
65
Bearing #6004-2RS (C0)
4
66
Round cap
2
67
C-clip S-40 (1.80T)
2
68
Waved washer D27*D20.3*0.5T
2
69
Flat washer D21*D8.5*1.5T
2
70
Fixing plate for idle wheel
1

8
71
Front pedal axle
2
72
Fixed bar
1
73
Flat washer D14xD6.5x0.8T
4
74
Bearing #99502
6
75
Handle pulse sensor
2
Handle pulse cable
2
76
Anti-loosen nut M10*1.25*10T
2
77L
Front left chain cover
1
77R
Front right chain cover
1
78
Upper protective cover
1
79
Flat washer D23*D17*1.2T
4
80
Flat washer D25xD8.5x2.0T
6
81
Bolt M5*0.8*10L
1
82
Screw ST4*1.41*15L
16
83
Knob
2
84
Screw ST4x1.41x20L
2
85
End cap
1
86
Adaptor
1
87
Chest belt
1
88
Inner tube
1
89
Club knob
4
90
Flat washer D12*D4.3*1T
16
91
Screw ST4x1.41x10.L
2
92
Screw cover
2
93
Buffer 20*90*1.7T
4
94
C-clip S-16(1T)
2

9
CHECKLIST (CONTENTS OF PACKAGE)

10
ASSEMBLY
STEP 1
1) Assemble the front stabilizer (2) and rear stabilizer (19) onto the main frame (1) by using the
allen bolt (3), the curved washer (6), the spring washer (7).
2) Adjust the proper height by turning the wheel of rear foot cap (4).
3) Assemble the left and right pedal (21L&21R) on the pedal supporting tube (11) by using the
carriage bolt (20), flat washer (73) and knob (89)
4) 3 optional positions for the pedals.