Motorola solutions Nntn8234 User manual

DUAL-UNIT

CHARGER

NNTN8234

USER GUIDE

en-US zh-CN zh-TW ko-KR

English

IMPORTANT SAFETY

INSTRUCTIONS

This document contains important safety

and operating instructions. Read these

instructions carefully and save them for

future reference.

Before using the battery charger, read all the

instructions and cautionary markings on (1)

the charger, (2) the battery, and (3) on the

radio using the battery.

WARNINGS

1. To reduce risk of injury,

charge only the

rechargeable Motorola

Solutions-authorized

batteries listed in Table 1.

Other batteries may

explode, causing personal

injury or damage.

2. Use of accessories not recommended by

Motorola Solutions may result in risk of

fire, electric shock, or injury.

WARNING

English

3. To reduce risk of damage

to the electric plug and

cord, pull by the plug rather

than the cord when

disconnecting the charger.

4. An extension cord should not be used

unless absolutely necessary. Use of an

improper extension cord could result in

risk of fire or electric shock. If an

extension cord must be used, make sure

that the cord size is 18 AWG for lengths

up to 100 feet (30.48 m) and 16 AWG for

lengths up to 150 feet (45.72 m).

5. To reduce risk of fire, electric shock, or

injury, do not operate the charger if it has

been broken or damaged in any way.

Take it to a qualified Motorola Solutions

service representative.

6. Do not disassemble the charger; it is not

repairable and replacement parts are not

available. Disassembly of the charger

may result in risk of electrical shock or

fire.

WARNING

English

7. To reduce risk of electric

shock, unplug the charger

from the AC outlet before

attempting any

maintenance or cleaning.

8. To reduce risk of injury, use

charger with Motorola Solutions-

authorized power supplies listed in

Table 2.

9. This is a Class A product. In a domestic

environment, this product may cause

radio interference in which case the user

may be required to take adequate

measures.

OPERATIONAL SAFETY

GUIDELINES

• This equipment is not suitable for outdoor

use. Use only in dry locations/conditions.

• Connect equipment only to an

appropriately fused and wired supply of the

correct voltage (as specified on the

product). Disconnect from line voltage by

removing main plug.

WARNING

English

• The socket outlet to which this equipment

is connected should be close by and easily

accessible.

• In equipment using fuses, replacements

must comply with the type and rating

specified in the equipment instructions.

• Maximum ambient temperature around the

power supply equipment must not exceed

40 °C (104 °F).

• Output power from the power supply unit

must not exceed the ratings stated on the

product label located at the bottom of the

charger.

• Make sure the cord is located where it will

not be stepped on, tripped over, or

subjected to water, damage, or stress.

BRIEF DESCRIPTION

The Dual-Unit Charger is intended for use with

the Motorola Solutions-approved Lithium-Ion

rechargeable batteries (listed in Table 1). The

front pocket of the charger is capable of

handling a radio with an attached battery. The

rear pocket is designed only to charge the

batteries (alone).

English

An illuminated LED indicates the state of

charge for the rear pocket; charge status in the

front pocket is indicated by the radio display.

The Dual-Unit Charger supports data pass

(from the radio to a PC) through the use of the

SKN6371C USB Cable (note: USB Data Cable

supplied separately).

OPERATIONAL GUIDELINES

• Always remember to power the Dual-Unit

Charger first before inserting the radio

handset with the attached battery into the

front pocket or the auxiliary battery into the

charger's rear pocket.

• Use the Data Cable for data ONLY. The

data cable will not support battery

charging.

• The front pocket has charging priority over

the rear pocket. Therefore, the handset in

the front pocket may completely charge its

battery before the battery in the rear

pocket begins charging.

English

MOTOROLA SOLUTIONS-AUTHORIZED

BATTERIES

The batteries listed in Table 1 are approved for

use with the Dual-Unit Charger.

Table 1: Motorola Solutions-Authorized

Batteries

Kit (Part)

Number Platform/Description

NNTN8020 Standard Capacity, Li-Ion

NNTN8023 High-Capacity, Li-Ion

PMNN4522 High-Capacity, IMPRES 2TM, Li-Ion

PMNN4801 IP68 1900T, IMPRES 2, Li-Ion

PMNN4802 IP68 3400T, IMPRES 2, Li-Ion

PMNN4582 IP68 2900T, IMPRES 2, Li-Ion

English

MOTOROLA SOLUTIONS-AUTHORIZED POWER SUPPLIES AND

COMPATIBLE KLAUS ADAPTERS

The power supplies listed in Table 2 are approved for use with the Dual-Unit

Charger.

Table 2: Motorola Solutions-Authorized Power Supplies and Compatible Klaus

Adapters

Power Supply

Kit Number

Klaus

Adapter Description Plug Type

NNTN8252_ SYN7455_