National Alloy User manual

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 800.482.1717.
Assembly Instrucon
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
Part # 2892080
Rev, -
Printed in U.S.A
© 2014 Kimball International, Inc.
Package Contents
Alloy
Ganging Kit
Hardware Qty
M8 x 45 Screw 4
Component Qty
Ganging Tube 2
Ganging Tube Cover 1
Tools Required
5mm Allen Wrench
1Remove crosslink tube ganging hole cover from both adjustable height
units to be ganged together as shown in Figure A.
3Align the opposite side of the ganging tubes to the second adjustable
height unit’s crosslink tube holes. Secure both ganging tubes using
the supplied screws as shown in Step 2.
2Align the rst ganging tube with the two holes in the crosslink tube. Us-
ing the supplied M8 x 45 screws secure one side of the ganging tube to
the adjustable height unit’s crosslink tube as shown in Figure B. Repeat
for the second ganging tube.
Note: Aach all ganging kits desired before installing either powered or
non-powered beam.
Figure A:
Ganging Hole Cover
Figure B:
Ganging Tube
Crosslink Tube

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 800.482.1717.
Assembly Instrucon
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
Part # 2892080
Rev, -
Printed in U.S.A
© 2014 Kimball International, Inc.
Package Contents
Alloy
Ganging Kit
Hardware Qty
M8 x 45 Screw 4
Component Qty
Ganging Tube 2
Ganging Tube Cover 1
Tools Required
5mm Allen Wrench
4Place the ganging tube cover over top of the two secured ganging
tubes as shown in Figure C.
Figure C:
Ganging Tube Cover