National WaveWorks User manual

Assembly Instructions
WaveWorks®
Metal Mobile Pedestal
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent. If you
have any questions concerning these instructions, please call National Customer Service.
CCAASSEEGGOOOODDSS
11Figure A
Telephone [phone]
Fax [phone]
www.nationalonline.com
Part # 2010777
Printed in U.S.A
© 2006 Kimball International, Inc.
Place pedestal on its side. Thread a
caster into each threaded mount on
the bottom of the pedestal (Figure A).
22Place washer and nut onto each caster
stem and tighten (Figure B). Stand
pedestal upright.
Recommended Tools
• Drill
• 1/4” and #2 Phillips tip bits
• Flat head screwdriver
• Round metal file
• Center punch
Package Contents Qty.
• Pedestal 1
• Casters 4
• Washers 4
• Nuts 4
Figure B
Pedestal Frame
33Removing Pedestal Box Drawer:
Extend drawer fully. Put one hand
underneath the drawer. Insert a flat
head screwdriver between the slide
and drawer body close to the front
engagement area to unlock drawer
(Figure C).
Figure C
Figure D
44Lift front of drawer up to disengage
from front drawer slide channel hooks.
When front of drawer is disengaged, pull
entire drawer towards you, supporting it
from the bottom. This should disengage
drawer from rear drawer slide channel
hooks (Figure D).
Nut
Washer
Caster

Assembly Instructions
WaveWorks®
Metal Mobile Pedestal
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent. If you
have any questions concerning these instructions, please call National Customer Service.
CCAASSEEGGOOOODDSS
55Figure E
Removing Pedestal File Drawer:
Extend drawer fully. Each drawer slide
has a lever; one is depressed, the other
is lifted. Simultaneously, while lifting and
depressing the levers, hold drawer level
and pull drawer towards you. This should
disengage drawer from pedestal (Figure E).