National Alloy User manual

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 800.482.1717.
Assembly Instrucon
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
Part # 3057148
Rev, -
Printed in U.S.A
© 2014 Kimball International, Inc.
Package Contents
Alloy
Adjustable Height
Single Center-Beam
Hardwire
1With the center beam upside down. Remove both hardwire juncon boxes
from the center beam as shown in Figure A.
Figure A:
2Remove the four screws securing the U-Channel to the center beam as
shown in Figure B.
3Have a licensed electrician wire and install the juncon boxes on the center
beam in the desired conguraon. Re-install the U-Channel and juncon
box / cover in reverse order of steps 1 &2.
Figure B:
Hardware Qty
M8 x 12 Screw 4
Self Driving Screw 4
Tools Required
5mm Allen Wrench
Screw Driver
#3 Phillips Driver

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 800.482.1717.
Assembly Instrucon
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
Part # 3057148
Rev, -
Printed in U.S.A
© 2014 Kimball International, Inc.
Alloy
Adjustable Height
Center-Beam
Hardwire
4Aach each crosslink to the already assembled single depth staon using
the M8x12 Flat Head screws as shown in Figure C.
5
Figure C:
Figure D:
Place the beam between the crosslink tubes as shown in Figure D.

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 800.482.1717.
Assembly Instrucon
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
Part # 3057148
Rev, -
Printed in U.S.A
© 2014 Kimball International, Inc.
Alloy
Adjustable Height
Center-Beam
Hardwire
From the boom of the beam align the two outside v grooves with the
four holes in the beam mounng brackets as shown in Figure E. Using
the four provided self-drilling screws secure the beam to the crosslink
tubes. Verify the beam is centered length wise between the crosslink
tubes on both ends. It is recommended to use a clamp and pads when
fastening the beam to help prevent misalignment.
6
Figure E: