National Alloy User manual

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 800.482.1717.
Assembly Instrucon
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
Part # 3057149
Rev, -
Printed in U.S.A
© 2014 Kimball International, Inc.
Package Contents
Alloy
Fixed Height
Single Center-
Beam Hardwire
1With the center beam upside down. Remove both hardwire juncon boxes
from the center beam as shown in Figure A.
Note: This instrucon will cover the assembly of hardwire xed height
center beams.
Figure A:
2Remove the four screws securing one U-Channel to the center beam as
shown in Figure B.
3Have a licensed electrician wire and install the juncon boxes on the center
beam in the desired conguraon. Re-install the U-Channel and juncon
box / cover in reverse order of steps 1 &2.
Figure B:
Hardware Qty
#8 x 1 Wood Screw 16
Self Driving Screw 4
Tools Required
Screw Driver
#2 Phillips Driver
#3 Phillips Driver

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 800.482.1717.
Assembly Instrucon
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
Part # 3057149
Rev, -
Printed in U.S.A
© 2014 Kimball International, Inc.
Alloy
Fixed Height
Single Center-
Beam Hardwire
4From the boom of the beam align the two inside v grooves with the four
holes in the at mounng brackets as shown in Figure C. Using the four
provided self-drilling screws secure the beam to the brackets. Verify the
beam is and brackets as aligned as shown below. It is recommended to
use a clamp and pads when fastening the beam to help prevent misalign-
ment.
Figure C:
1/2” Inset:
1/2” Inset:

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 800.482.1717.
Assembly Instrucon
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
Part # 3057149
Rev, -
Printed in U.S.A
© 2014 Kimball International, Inc.
Alloy
Fixed Height
Single Center-
Beam Hardwire
Align the beam assembly to the underside of the worksurface. Use the
16 provided wood screws to secure the assembly as shown in Figure D.
Aach the table frame to the worksurface.
5
Figure D: