National Alloy User manual

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 800.482.1717.
Assembly Instrucon
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
Part # 2951092
Rev, -
Printed in U.S.A
© 2014 Kimball International, Inc.
Package Contents
Alloy
Fixed Height Single
Bases
Hardware Qty
M6 x 12 4
Handle 2
Lock Plate 2
Mounting Bracket 2
Woodscrews 4
Tools Required
4mm Allen Wrench
Screw Driver
#2 Phillips Bit
Note: This assembly instrucon will cover all conguraons of Alloy
xed height double bases.
1Assemble the two adjustable upper channels as shown in Figure A. Using
the supplied handle and lock plate roughly set the length of the adjustable
channel to the desired surface size and conguraon ordered in Figure B.
Do not fully ghten the lock plate.
Figure A:
Figure B:
Surface Size Freestanding:
48 39 1/2”
54 45 1/2”
60 51 1/2”
66 57 1/2”
72 63 1/2”
2Using the tabs as shown in Figure C, aach one side of the adjustable
upper channel to the rst end leg.
Figure C:

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 800.482.1717.
Assembly Instrucon
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
Part # 2951092
Rev, -
Printed in U.S.A
© 2014 Kimball International, Inc.
Package Contents
Alloy
Fixed Height Single
Bases
Hardware Qty
M6 x 12 4
Handle 2
Lock Plate 2
Mounting Bracket 2
Woodscrews 4
Tools Required
4mm Allen Wrench
Screw Driver
#2 Phillips Bit
3Verify the upper channel is fully seated as shown in Figure D. Using the
mounng bracket and M6 x 12 screws provided, secure the adjustable
upper channel to the end leg as shown in Figure E.
4Repeat steps 2-3 to secure the opposite end leg. Once complete, the en-
re frame should be constructed to your desired conguraon.
Figure D:
Figure E:

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 800.482.1717.
Assembly Instrucon
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
Part # 2951092
Rev, -
Printed in U.S.A
© 2014 Kimball International, Inc.
Package Contents
Alloy
Fixed Height Single
Bases
Hardware Qty
M6 x 12 4
Handle 2
Lock Plate 2
Mounting Bracket 2
Woodscrews 4
Tools Required
4mm Allen Wrench
Screw Driver
#2 Phillips Bit
7Once the surface is secured. Fully ghten down the handle and lock
plates from Step 1 on the adjustable upper channel.
6Pull the adjustable upper channels / frame into nal posion. Secure
the nal end leg to the surface using the dimensions shown in Figure G.
5Aach the worksurfaces to one end of the frame using the provided wood-
screws. Center the worksurface width wise on the end leg. Reference the
dimension in Figure F for locaon of the surface length wise.
1 9/16”
Figure G: