National LOCHLYN CORNICE TOP User manual

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 800.482.1717.
Assembly Instrucon
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
3249055
Rev, -
LOCHLYN
CORNICE TOP
TOOLS REQUIRED
DRILL DRIVER W/#2 PHILLIPS BIT
NON MARRING CLAMPS
MASKING TAPE
HARDWARE
BRACKETS QTY VARIES
#8X1” PAN HEAD SCREWS
QTY VARIES
#8X5/8” SELF TAPPING SCREW
QTY VARIES
1
UNPACK AND POSITION THE TOP OVER THE FRAME (FIGURE A). SQUARE THE TOP
TO THE FRAME THEN CLAMP DOWN LIGHTLY WITH A NON MARRING CLAMP.
FIGURE A
FIGURE B
2
RETRIEVE THE ANGLED BRACKETS AND SCREWS FROM THE HARDWARE KIT. THE
BRACKETS WILL BE ATTACHED TO THE DEPTH CROSS MEMBERS ALONG THE FRAME
WITH SELF TAPPING SCREWS AND TO THE TOP WITH STANDARD PAN HEAD SCREWS.
POSITION ONE OF THE BRACKETS APPROX. 2” INSIDE THE HORIZONTAL RAIL TO CLEAR
THE JUNCTION BLOCK (FIGURE B). START AND RUN DOWN THE 1” PAN HEAD SCREW TO
MOUNT IT TO THE WORKSURFACE.
NOTE: ENSURE THE SHORT ARM OF THE BRACKET IS ALONG THE FRAME AND THE LONG
SIDE TO THE WORKSURFACE.
TIP: USE MASKING TAPE AND APPLY A STRIP TO HOLD THE BRACKET TO THE FRAME AND
ANOTHER STRIP TO THE WORKSURFACE. THIS HOLDS THE BRACKET IN POSITION DURING
INSTALLATION AND FREES UP A HAND.

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 800.482.1717.
Assembly Instrucon
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
3249055
Rev, -
LOCHLYN
CORNICE TOP
3
MOUNT THE SECOND BRACKET TO
WORKSURFACE ON THE OPPOSITE
SIDE APPROX. 2” IN FROM THE
HORIZONTAL MEMBER (FIGURE C).
FIGURE C
4
START AND RUN DOWN SELF TAPPING SCREWS INTO EACH BRACKET TO MOUNT IT
TO THE FRAME (FIGURE D).
FIGURE D
5
REPEAT STEPS 2-4 FOR EACH OF THE REMAINING CROSS SECTIONS ON THE FRAME
UNTIL ALL HAVE 2 BRACKETS ATTACHED (FIGURE E). INSTALLATION IS COMPLETE
AFTER THIS STEP.
FIGURE E